Advertisement
Quick Links
& Load Shedding
This indicator shows when the pool is being heated. It
will turn on and off automatically in Auto and Manual
modes when heating is required.
Load Shedding
( keeping power within design limits ) is an arrangement
predefined at manufacture which, dependent on system and
components used, will switch either the heating element or
accessories on and off to keep within the Controllers power
limits.
The switch normally beeps every time a button is pushed. These
can be switched off by holding down the Up button and
simultneously pushing the Light button. To switch on again repeat
the above.
The Display normally always returns to the pool temperature. If
you want the display to stay on Time, then pushing the display
button until time is shown and pressing the Down button will lock
the display in this mode. The temp display can be restored at any
time by pushing the Display button.
QUICK CARD - USER GUIDE FOR THE
DIGITAL 2000 SERIES SPA CONTROLLERS
DUAL SPEED VERSION
Please read these instructions carefully
Advertisement
Subscribe to Our Youtube Channel
Related Manuals for Spa-Quip Digital 2000 Series
Summary of Contents for Spa-Quip Digital 2000 Series
- Page 1 This indicator shows when the pool is being heated. It QUICK CARD - USER GUIDE FOR THE will turn on and off automatically in Auto and Manual DIGITAL 2000 SERIES SPA CONTROLLERS modes when heating is required. DUAL SPEED VERSION...
- Page 2 revert to the water temperature reading after a short time. By This button controls the Booster pump. A green LED indicates following the above procedure the desired pool temperature can be set, the Time of Day and the Sleep start and finish times. The time when the pump is on.
Need help?
Do you have a question about the Digital 2000 Series and is the answer not in the manual?
Questions and answers