Empire DVP20CCKR-1 Installation Instructions

INSTALLATION INSTRUCTIONS
DVP20CCKR-1 - For use on Models DVP20CC(30,70)
INSTRUCTIONS MUST BE LEFT WITH OWNER FOR REFERENCE AFTER INSTALLATION.
Tools Needed:
• 5/16 Nut Driver
Instructions
1. Remove casting top and front from fireplace.
2. Remove glass door from fireplace. Open the two door
clips located on the bottom left and right of glass door.
See Figure 1.
3. Remove logs from fireplace. Place logs in an area
where they will not be broken.
4. Remove inner baffle from fireplace using a 5/16" nut
driver to remove the two screws for DVP20CC and 4
screws for DVP30CC. See Figure 2.
(DVP20CC Shown)
30997-2-0217
Figure 1
Figure 2
Empire Comfort Systems, Inc. • Belleville, IL
MODELS:
DVP30CCKR-1 - For use on Models DVP30CC(30,70)
U:\INSTRUCTIONS\Instructions Original Graphics\Cast Iron Stove - DVP(20,30)CC - 2013\CDR\Remove screw from brac
5. Remove rear log support from fireplace using a 5/16"
nut driver. See Figure 3.
6. Remove the rearward screw from each of the two
BlowPlate Brackets. Removal of these two screws
eliminates interference when installing the rear liner
panel. See Figure 4.
7. Install left reflective panel into the fireplace. See Figure 5.
Figure 3
BLOW PLATE
BRACKET
Figure 4
Figure 5
Page 1