Partial flow commercial room ventilator 24 volt on/off with spring return and exhaust. for use with bard single stage wall mount air conditioner and heat pump models: w42ac, w48ac, w60ac, w72ac, w42hc, w48hc, w60hc (17 pages)
Depending on the tightness of the structure, 0.1 return air static pressure. an independent exhaust provision may be needed to obtain the ventilation air quantities shown. TABLE 1 WGMFAD-3 VENTILATION AIR For use with WG24 Model l i t l i t l i t...
Page 4
TABLE 2 WGMFAD-3 VENTILATION AIR For use with WG30 and WG36 Models l i t l i t INSTALLATION Step 4. Install WGMFAD with notch in front lip of WGMFAD centered over hole in condenser Step 1. Disconnect all power to unit before installing partition.
TABLE 3 WGMFAD-5 VENTILATION AIR For use with WG42, WG48 and WG60 Models l i t l i t l i t the unit installation instructions for wiring diagram. Step 6. Route wires as shown in Figure 3A into unit low voltage terminal strip area.
FIGURE 1 VENT OPTION DOOR TO BE REMOVED FRONT DOOR VENT OPTION DOOR FIGURE 2 EXHAUST COVER PLATES MUST BE IN PLACE MIS-1447 EXHAUST COVER PLATES MIS-1447 Manual 2100-362C Page...