Trident NM14 Use And Maintenance Manual

Scrubbing machine

Advertisement

Quick Links

Scrubbing machine
Use and Maintenance manual
ORIGINAL INSTRUCTIONS DOC. 10075414 - Ver. AA - 11-2017

Advertisement

Table of Contents
loading
Need help?

Need help?

Do you have a question about the NM14 and is the answer not in the manual?

Questions and answers

Summary of Contents for Trident NM14

  • Page 1 Scrubbing machine Use and Maintenance manual ORIGINAL INSTRUCTIONS DOC. 10075414 - Ver. AA - 11-2017...
  • Page 3: Table Of Contents

    CONTENTS GENERAL SAFETY CONTENTS ................3 REGULATIONS GENERAL SAFETY REGULATIONS ........3 RECHARGING THE BATTERIES............ 4 The following symbols are used to indicate USING THE MACHINE ............... 4 any potentially hazardous situations. Always DEACTIVATION OF THE MACHINE ........... 6 MAINTENANCE .................. 6 read this information carefully and take the TRANSPORT ..................
  • Page 4: Recharging The Batteries

    RECHARGING THE BATTERIES DANGER: • If the battery charger power cable is damaged or broken, it should be replaced by the manufacturer, by authorised service personnel or else by a qualified person, in order to protect against hazards. • Keep sparks, flames, and incandescent materials at a safe distance from the batteries. •...
  • Page 5 • Do not use the machine without the requisite knowledge and authorisations. • Do not use the machine if you have not read and understood the following user manual. • Do not use the machine under the influence of alcohol or drugs. •...
  • Page 6: Deactivation Of The Machine

    • Use only the brush supplied with the machine or those specified in the following manual. Using other brushes compromises the safety of the machine and its operator. • Before starting work check that there are no leaks. • Before starting work check that all the safety devices have been installed and are working correctly.
  • Page 7: Transport

    • Restore all electrical connections after any maintenance interventions. CAUTION: • For any maintenance work, switch the machine off using the main switch, remove the battery from the battery compartment. • Avoid contact with moving parts. Do not wear loose clothing or jewellery and tie up long hair. ATTENTION: •...
  • Page 8: Symbols Used In The Manual

    The TRIDENT NM14 is a floor scrubbing machine that cleans a wide range of flooring and dirt types by means of the mechanical action of a cylindrical brush and the chemical action of a water-detergent...
  • Page 9: Spare Parts

    18 Kg. tank are full. The packaging dimensions are as follows: TRIDENT NM14 10,6 BATTERY TYPE 19,2 To power the appliance, use only the battery supplied in the packaging or one supplied by a specialised technician.
  • Page 10: Machine Preparation

    PREPARING TO WORK Before beginning to work, it is necessary to: N.B.: before beginning the first work cycle, fully recharge the battery (read “RECHARGING THE BATTERY”). 1. Before using the machine, make sure it is in a good, safe working condition. If everything is not in order, the machine must not be used.
  • Page 11: Work

    WORK Before beginning to work, it is necessary to: 6. Remove the battery from the battery compartment using the handle moulded on it (Fig.4). 7. Rotate the front carter (5) as far as it will go - do this with the aid of the handle (6) (Fig.5). 1.
  • Page 12: Maintenance

    16. Rinse the inside of the tank with a jet of water. 17. Insert the drain cap (10) in its seat on the detergent solution tank (Fig.13). 18. Remove the solution tank from the machine (Fig.14). 19. Remove the filling cap (11) from its seat on the solution tank (Fig.15). MAINTENANCE At the end of the work, and before carrying out any type of maintenance, perform the following operations:...
  • Page 13: Troubleshooting

    34. Make sure the squeegee body is in the work position. If it isn't, turn the knob (18) in the direction • Remove the used filter cartridge (29) from the filter cartridge support (28) and replace it with of the arrow (Fig.26). the new one (Fig.41).
  • Page 14: Disposal

    PROBLEM POSSIBLE CAUSE SOLUTION Read the section “THE The machine does not start. MACHINE DOES NOT START”. Read the section “NOT Not enough detergent solution ENOUGH DETERGENT comes out. SOLUTION ON THE THE MACHINE DOES NOT BRUSH”. CLEAN CORRECTLY The brush is not correctly Insert the brush correctly in inserted in the machine.
  • Page 16 HILLYARD INDUSTRIES - PO Box 909 - St.Joseph, Missouri 64502-0909 U.S.A. - Telephone: 816-233-1321 - www.hillyard.com...

Table of Contents