Iala; Rtk; Monitoring Points Configuration - Kongsberg DPS 232 Installation Manual

5.5.5 IALA

The IALA view offers IALA beacon receiver
configuration. The
Search mode
DGNSS interface to switch IALA beacon off, search
for information automatically, or set the frequency and
MSK bit rate manually.
By default, IALA search mode is set to Auto.

5.5.6 RTK

This setting can be changed to optimize the performance in RTK mode. The
has three selections: Off, RTK and Float and Float only. The default setting
option
is RTK and Float.
How and when to change the default RTK settings
1 The Glonass option for the RTK solution can be changed from the default setting
to
RTK and Float
The
RTK and Float
correction source is known (own local reference station). The
used when the system has problems with getting an RTK solution. The
is used when the RTK corrections include only two-frequency GPS corrections.
Figure 27 RTK view

5.6 Monitoring points configuration

The system supports up to eight user definable monitoring points. These are defined
in the Monitoring Points view.
As soon as a monitoring point has been defined, its location is indicated in the vessel
outline for easy visual verification. The monitoring points are given relative to Origin
(positive forward, towards starboard and down). The position of a monitoring point
relative to the Origin is indicated in the drawing when the cursor is over the monitoring
point.
If a monitoring point appears incorrect, check the signs and the coordinates input for
each monitoring point, the vessel dimensions and the entered location of Origin.
G210-14/3.0
list box allows the
or by pulling down the
Float only Off
selection is recommended used under conditions where the RTK
Configuration
Figure 26 IALA view
Glonass
drop-down list.
Glonass option
selection is
Float only
selection
Off
59