Standard Nav Engine Configuration - Kongsberg DPS 232 Installation Manual

Kongsberg DPS 232
Operation mode
This is the default mode. In this mode it is not
possible to launch any external applications,
diagnostic tools or reconfigure the system.
Configuration mode
In this mode it is possible to configure NAV
Engine and the operator software. Settings
related to externally connected equipment is
configured from NAV Engine.
Engineering mode
This mode is primarily intended for field engineers during initial installation, fault
diagnostics and system-wide reconfiguration.
A password is required to switch from Operation to Engineering or Configuration
mode. The password is "stx", and it is not possible to change. The system will return to
Operation mode after 30 minutes of user inactivity.

5.3 Standard NAV Engine configuration

Configuration of NAV Engine is available from
the menu. Two configuration modes are
System
available, and
Standard
The configuration is available when
Standard
logged into Configuration mode and Engineering
mode.
The configuration is available in
Advanced
Engineering mode only and should only be used
by service engineers.
The configuration provides the most user friendly access to system
Standard
configuration, and is recommended for most configuration tasks. The
configuration menu is illustrated.
48
.
Advanced
Figure 11 Change system mode
menu
Figure 12 NAV Engine
configuration
Standard
G210-14/3.0