Lite-Check 137 Operation Manual

Output tester

TRACTOR OPERATION

ELECTRICAL OPERATION – RP 137C ABS supply, RP 141 trailer ABS power required,

RP 144 cab ABS lamp

✓ Auxiliary circuit has 5-amp load, brake circuit has 5-amp load, running lights

have a 5 -amp for a total of 15-amps with all circuits

1. Set tester switch to tractor.

2. Turn on ignition (battery output if engine is not running, alternator output with engine).

3. With 5-amp load, tester shows voltage available on ABS auxiliary line.

4. Trailer ABS lamp in cab will cycle indicating circuit is working.

5. Depress brake pedal to activate circuit with 5-amp load to show available voltage.

6. Turn on running lights and turn signals one at time to show available voltage.

AIR OPERATION – RP 619B, Air System Inspection

7. Release trailer parking brakes- observe air gauge with compressor operating.

8. Press brake pedal to apply service brakes – observe air gauge for pressure.

9. Turn off engine with ignition switch on and trailer parking brake applied.

10. Press brake pedal repeatedly to test low air warning system and observe pressure.

MODEL 137 OUTPUT TESTER

OPERATION MANUAL

– Connect 7-w cable and 2 airlines

Table of Contents

Do you have a question about the 137 and is the answer not in the manual?

Page 1 MODEL 137 OUTPUT TESTER OPERATION MANUAL TRACTOR OPERATION – Connect 7-w cable and 2 airlines ELECTRICAL OPERATION – RP 137C ABS supply, RP 141 trailer ABS power required, RP 144 cab ABS lamp ✓ Auxiliary circuit has 5-amp load, brake circuit has 5-amp load, running lights have a 5 -amp for a total of 15-amps with all circuits 1.
Page 2 TRAILER & DOLLY OPERATION – Connect MODEL 137 OUTPUT TESTER 7-w cable and airlines to vehicle output Set tester switch to trailer Connect LITE-CHECK INSPECTOR 920 with LITE-CHECK 313S Power supply as source power and air ELECTRICAL OPERATION with INSPECTOR 920 - RP 137C ABS supply, RP 141 trailer ABS power required Press SELECT (yellow button) to apply more than one circuit.