Inter-m VDC-272 Operating Manual

INSTALLATION

• LENS MOUNTING
Take-out the rubber cap before mounting the lens. This camera can use either C or CS
type mount lenses and it fixed C mount from factory. Remove the C mount adaptor by
tuning it counter-clockwise of the camera body when use CS mount lens. Mount the lens
by turning it clockwise onto the lens mount of the camera and connect the lens cable to
the Iris Lens when an auto iris lens is used.
• MOUNTING THE CAMERA STAND
This camera has the mounting foot on the bottom. To move the mounting foot, remove
the two screws holding the foot to the camera body and move the foot to the top and
reattach it with the two screws.
• CONNECTING THE VIDEO CONNECTOR
Plug the BNC jack from the monitor or other device to the BNC connector on the back of
the camera.
• CONNECTING THE POWER
Connect the power source (DC 12V) to the camera.

FOCUS ADJUSTMENT AT ZOOM LENS

This camera selected variable back focus system which is easy adjusted lens focus.
1) Fit in zoom lens and loosen the focus screw with L-wrench count-clockwise.
2) Adjusted lens focus to obtain the sharpest picture on the screen at maximum zoom in
position.
3) Checked sharpest picture on screen at zoom out position.
4) Repeated 2) and 3) process with correct focus with zoom-in and zoom-out position.
After that fixed focus screw with L-wrench.

TROUBLESHOOTING

• If there is no picture on the monitor screen,
–make sure all the cables are properly connected.
–make sure the monitor is properly adjusted.
• If a picture on the monitor screen is not clear,
–clean the lens.
–adjust the lens focus.
• If there is a video noise or other unknown problems,
–stop using the camera and call your local dealer.
OPERATING MANUAL
MADE IN KOREA
NO: 9007908010
1 / 3 " C O L O R
CAMERA
VDC-272, VDC-412
C C D