Instructions For Use; Preparing For Use; Check Parts & Accessories; Conduct Test Run With Water Only - Tristar Products Power Quick Pot Y4D-36 Owner's Manual

Instructions for Use

A. PREPARING FOR USE
CHECK PARTS & ACCESSORIES
1. Before using, remove parts and accessories
from package and be sure all parts have been
included before discarding any packaging
materials. Remove all packing materials such
as plastic film, cardboard, and stickers on the
Pressure Release Valve and Condensation
Collector. See PARTS & ACCESSORIES, p. 10.
2. CLEAN INSIDE: Remove the Inner Lid from Lid
by pulling metal knob. Remove Rubber Gaskets

CONDUCT TEST RUN WITH WATER ONLY

FIG. A
(Float Valve Rubber Gasket)
1. To check that the Unit will operate properly,
it is recommended to periodically check its
operation without food.
2. Place the Power Quick Pot on a clean, flat
surface.
3. Attach Condensation Collector to side of
the Unit by sliding it into the slots (see Fig. B).
NOTE: The Condensation Collector may be
preassembled.
14
4-, 6-, 8-, 10-Quart Power Quick Pot™
FIG. B
(Condensation Collector)
from Inner Lid, see INNER LID ASSEMBLY,
p. 12. Wash Inner Lid, Rubber Gasket, Inner
Pot, and other loose accessories with warm,
soapy water, rinse and dry. NOTE: Be sure
to replace Rubber Gaskets (see CHANGING
THE INNER LID RUBBER GASKETS AND
FLOAT VALVE ASSEMBLY sections) before
reinstalling Inner Lid.
4. Remove the Lid. Ensure the Inner lid gaskets
are in place. Place the Inner Lid Outer Gasket
around the outside of the Inner Lid and the Inner
Lid Center Gasket in the center hole. Make sure
the float valve and gasket are in place in the lid.
See ASSEMBLY INSTRUCTIONS.
5. Place the Inner Pot in the Base. Pour 2 cups
(473 mL) of water in the Inner Pot.
6. Attach the Power Cord to the Unit Base first
and then into wall outlet. See the ATTACHING
THE POWER CORD, p. 5. When the Unit is first
plugged in, "----" will appear on the LED Display.
The Unit is automatically "ON" when plugged in.
7. ATTACHING LID: With the LCD Display facing
you, place the Lid on the Unit, aligning the Lid
Position Mark with the Open Mark (see Fig. C).
Twist the Lid counterclockwise about 30° (see Fig.
D). When the Lid is locked, the Release Switch will
move to the Closed position (see Fig. E).