Honda Jazz 2018 Owner's Manual page 177

18 FIT JAZZ-32T5A6100.book 176 ページ ２０１７年８月２３日 水曜日 午前１１時２４分
uuOperating the Switches Around the Steering WheeluAuto High-Beam (High Beam Support System)
■
Operating the System
Headlight Switch
The high beams remain on unless:
• You have been driving below 24km/h (15mph) for an extended amount of time.
• The speed of the vehicle drops below 10km/h (6mph).
• The windshield wipers have been running at a high speed for more than a few
seconds.
• You enter a well lit location.
The high beams come back on once the condition that caused them to turn off no
longer exists.
* Not available on all models
176
To activate the system, turn the headlight
switch to AUTO and then set the headlights
to low beam. The auto high-beam indicator
will come on.
2 Light Switches P. 170
*
1Operating the System
For the auto high-beam to work properly:
•
Do not place an object that reflects light on the
dashboard.
•
Keep the windscreen around the camera clean.
When cleaning the windscreen, be careful not to
apply the windscreen cleanser to the camera lens.
•
Do not attach an object, sticker or film to the area
around the camera.
•
Do not touch the camera lens.
If the camera receives a strong impact, or repairing of
the area near the camera is required, consult a dealer.
To help reduce the likelihood that high interior
temperatures will cause the camera system to shut
off, when parking, find a shady area or face the front
of the vehicle away from the sun.
If you use a reflective sun shade, do not allow it to
cover the camera housing. Covering the camera can
concentrate heat on the camera.
If the message appears:
•
Use the heating and cooling system
control system * to cool down the interior and, if
necessary, also use defroster mode with the air
flow directed towards the camera.
•
Start driving the vehicle to lower the windscreen
temperature, which cools down the area around
the camera.
* /climate