Network Profile Configuration - Samsung FLIGHT SGH-A797 Series User Manual

Touch .
3. Save

Network Profile Configuration

Your phone is wirelessly connecting to the Internet via a built in
WAP browser. Connection can be made via either one of three
available WAP browsers: MEdia Net, AT&T MMS (MultiMedia
Server), and AT&T IMS. These configurations are pre-configured
and cannot be modified by the user. You need these settings to
use the web browser or send MMS messages or Emails. Your
phone is set up by default to connect to the internet.
You can use this menu to create and customize the profiles
containing the settings for connecting your phone to the network.
Although the active connection can be changed by the user, it is
recommended that this choice be made with the assistance of
either the retailer or customer service representative.
To create a new configuration, follow these steps:
From Idle mode, touch
1.
Network Profiles.
Touch Create .
2.
Select the parameter you want to add or edit:
3.
• Set Name: enter a profile name.
• Access Name: edit the access point name.
58
➔ ➔ ➔
Settings Connectivity
• Auth Type: select the type of authentication used for this WAP
connection: None, Normal, or Secure.
• User ID: enter the User ID required to connect to the network.
• Password: enter the user password required to connect to the
network.
• Protocol: set the connection protocol used by the WAP browser:
WAP, HTTP, or Other.
• Home URL: enter the URL address of the page to be used as your
homepage.
• Proxy Address: MEdia Net set as the proxy server address and
port.
• Linger Time (sec.): set a time period (in seconds) after which the
network is disconnected if there has been no new data traffic in that
time.
• Advanced Settings: allows you to configure some of the IP-specific
information: Static IP, Static DNS, Server information, and Traffic
Class.
– Static IP: specify if you want to manually enter an IP address. If you
want the IP address to be automatically assigned by the server, remove
the check mark.
– Static DNS: specify if you want to manually enter the Domain Name
Server (DNS) address. If you want the address to be automatically
assigned by the server, remove the check mark.
– Traffic Class: select the traffic class.