Bering RADIO-CONTROLLED Operating Instruction page 5

MANUAL TRANSMITTER CALL
1. Press T1 until the hands start moving (>3 seconds). The hands advance to the 12:00 o'clock position, digits on the LCD
change to „00" and the radio tower flashes. In case of the 12:00 o'clock position not being reached precisely, please follow
the information on „Reset".
T1 > 3 sec.
2. For good reception, it is best to hold your radio-controlled watch still and away from possible sources of interference
such as: telephone, PC, TV, etc.
3. Your radio-controlled watch will set itself automatically after a few minutes and the transmitter call is completed.
4. A premature transmitter call abortion is possible by briefly pressing T1. The saved time is then displayed.
BATTERY REPLACEMENT (CR1620)
As a special tool is needed to open and close the base of the glass case, a battery replacement has to be performed by a
watch specialist in order to prevent damage to the case and the seals.
RESTART FOLLOWING BATTERY REPLACEMENT
1. 1. After inserting the battery, is displayed on the LCD.
If this is not the case, then please perform a reset (T2 > 16 seconds).
2. By pressing T1, you can now set the hands to the 12:00 o'clock position.
a. Briefly pressing and releasing T1 changes the hands of your radio-controlled watch step by step.
b. By pressing T1 longer, your radio-controlled watch alternates to a fast-forward mode. After releasing T1, the hands
stop immediately.
c. You can now precisely set the radio-controlled watch in individual steps (alternately press briefly and release)
3. If you have now determined the 12:00 o'clock position, confirm it by pressing T2. The positioning of the hands is now
complete. A visible sign that the reception has begun is the LCD alternating from
4. During the reception of your radio-controlled watch, the hands stay in the 12:00 o'clock position and the radio tower
is displayed.
5. In the case of bad reception or locations outside the transmitter range, your radio-controlled watch will not succeed in
receiving time information. Therefore, either change your location or remove possible sources of interference to guaran-
tee reception. Your radio-controlled watch autonomously restarts the reception process every 6 hours.
NOTE ON HAND POSITIONING: if you briefly press T2 before having reached the correct position of the hands, the position of
the hands is considered as terminated. To correct the hands now, please perform a reset again.
RESET
In case of your watch having a malfunction, press
press T1 and T2 (>3 seconds) simultaneously until the LCD switches off. This is easily done with an appropriate tool such
as pointed tweezers. As soon as the button is released, the microprocessor performs a „reset"; all saved time information
is deleted. The LCD now shows:
to
Now follow the information on RESTART FOLLOWING BATTERY REPLACEMENT.
T2 (>16 seconds) until the LCD switches off. Alternatively, you can also