Nero 74409099 User Manual page 4

Before Using For the First Time
Do not posi on this appliance with its rear panel directly against a wall. For good circula on and
opera ng efficiency, the ven la on grilles must never be blocked.
Remove all packaging and place the Fridge on a stable, secure flat surface. Posi on the
Fridge away fr om heat sources, where the unit is well -ven lated and protected from
moisture, or extremes of heat or cold. The refrigerator may not func on properly if the ambient
temperature rises above +40 for prolonged periods of me.
Ensur e the vents behind the fridge are clear, and clean, and not obstructed from the other side,
such that air circula on is enabled.
Do Not Use An Extension Lead. If the mains cable will not reach the nearest socket, either
rearrange your installa on layout or ask a qualified electrician to fit a new socket.
If power is cut off, wait for at least 5 minutes before plugging the unit in again to avoid damaging
the compressor.
Do not place combus ble, explosive or vola le ar cles, corrosive acid or alkali, or liquid in glass
containers into the Fridge .. Always exercise cau on if adjus ng the temperature.
IMPORTANT: allow the refrigerator to stand still and
upright for 8 hours before plugging it into the power!
Cleaning
1 Unplug your Fridge from power source and remove any items from inside. It is best to
place these temporarily in another refrigerator.
2. Wash the inner compartment with warm water and neutral mild detergent. DO NOT allow the
control panel, cables or plug to get wet.
NEVER use corrosive detergents, wire blasters, or abrasive scourers to clean your
Fridge.
NEVER use metal or sharp implements to scrape any part of the fridge.
3. Dry all surface thoroughly.
4. To ensure trouble -free opera on the condenser should be cleaned every three months where
appropriate using a vacuum hose. The condenser is located behind lower grill of the cabinet. In
excep onally dusty.
It is recommended that areas around the condenser are cleaned more o en.
5. Use mild soapy water to clean the gasket and seals around the door.
6. The external surfaces of the fridge can be cleaned with warm water and mild detergent.
4
There are several types of controller/thermostat for different models.
Please check which type of controller on your unit.
Mechanical
Controller
The mechanical thermostat temperature control and the LIGHT on/off switch is located
at below places:
Type Ⅰ:
Thermostat se ngs
Thermostat "0" posi on indicates the Refrigerator is turn off although
power is s ll being supplied. By turning the thermostat dial clockwise,
Light Switch
the Refrigerator will turn on automa cally. The se ngs 1(MIN) - 7 (MAX)
regulate the interior temperature of the Refrigerator.
Se ng 0 = Off (not opera ng)
Se ng 1 (or MIN) = lowest se ng (warmest internal temperature)
Se ng 7 (or MAX) = highest se
Thermostat
Adjust the internal temperature as required according to the amount of
control
product and the ambient temperature.
The internal temperature varies in different parts of the Refrigerator.
The back of the Refrigerator is coldest.
Thermostat se ngs
Type Ⅱ:
The se ng 1(MIN)-5(MAX) regulate the interior temperature.
Back of unit
Se ng 1 (or MIN) = lowest se ng (warmest internal temperature)
Se ng 5 (or MAX) = highest se ng (coldest internal temperature)
To operate
1.
2
1
3
2.
5
4
Tips for refrigera on
Type Ⅲ:
Thermostat se ngs
Thermostat "OFF" posi on indicates the Refrigerator is turned off although
Thermostat control
Light Switch
power is s ll being supplied. By turning the thermostat dial clockwise,
the Refrigerator will turn on automa cally. The se ngs MIN - MAX
7 regulate the interior temperature of the Refrigerator.
6
OFF
ON
Se ng Off = not opera ng
Se ng MIN = lowest se ng (warmest internal
temperature)
Se ng MAX = highest se
temperature)
Adjust the internal temperature as required according to the amount of
product and the ambient temperature.
The internal temperature varies in different parts of the Refrigerator. The
back of the Refrigerator is coldest.
LOOKING AFTER THE PRODUCT-DEFROSTING:
Ice may build up on the evaporator if the unit is put to work constantly for a period of me. When ice begins to build up to
approx 10 mm or1/5 inch thick, defrost is required.
Empty the cabinet of the products that must stay at cold condi on. Switch the thermostat to "OFF"posi on.
The ice will start to melt. When the ice has melted and drained away, dry off any residual moisture with a so cloth. Switch on the
power again via thermostat.
Please note it will take around 12 hours for the cabinet to get back down to temperature with the products.
5
ng (coldest internal temperature)
The temperature in the appliance is controlled by the temperature
control knob located on the rear of the fridge on the outside of the
product. Rotate the control knob le or right to regulate the temp-
erature inside the fridge, you may need a flat headed screw driver
or a coin to do this.
To
turn
the
unit
off,
disconnect
the
plug
from
the
mains
supply.
4
3
ng (coldest internal
2
5
MAX
OFF
MIN
1