Zircon iLine Instructions

i
Line ™ Automatic Laser Level
The Zircon iLine ™ is a simple
and fast tool that gives you a
bright laser plumb or level line.
It fits in your hand or pins easily
to a wall. Turn iLine ™ up, down,
left, right—it automatically
levels in all four directions.
Battery Compartment
(Back of unit)
LIMITED 1 YEAR WARRANTY
Zircon Corporation, ("Zircon") warrants this product to be free from
defects in materials and workmanship for one year from the date of
purchase. Any in-warranty defective product returned to Zircon*, freight
prepaid with proof of purchase date and $5.00 to cover postage and
handling, will be repaired or replaced at Zircon's option. This warranty is
limited to the electronic circuitry and original case of the product and
specifically excludes damage caused by abuse, unreasonable use or
neglect. This warranty is in lieu of all other warranties, express or
implied, and no other representations or claims of any nature shall bind
or obligate Zircon. Any implied warranties applicable to this product are
limited to the one year period following its purchase.
IN NO EVENT WILL ZIRCON BE LIABLE FOR ANY SPECIAL, INCIDENTAL
OR CONSEQUENTIAL DAMAGES RESULTING FROM POSSESSION, USE OR
MALFUNCTION OF THIS PRODUCT.
In accordance with government regulations, you are advised that:
(i) some states do not allow limitations on how long an implied warranty
lasts and/or the exclusion or limitation of incidental or consequential
OPERATION
Pull cover open to turn on.
4
i
Place Line on wall
5
and move until laser
is in desired position.
Note: i Line can be held in
place or secured to wall
with supplied pin.
Ensure laser
6
swings freely.
Gently tap the unit
7
to settle the laser
line on level.
Pin Hole
damages, so the above limitations and/or exclusions may not apply to
you, and further (ii) this warranty gives you specific legal rights and you
may also have other rights which vary from state to state.
Return product freight prepaid with proof of purchase date (dated sales
receipt) and $5.00 to cover postage and handling, to:
Zircon Corporation
*Attn: Returns Department
1600 Dell Avenue, Unit K
Campbell, CA 95008-6992 USA
Be sure to include your name and return address. Out of warranty serv-
ice and repair, where proof of purchase is not provided, shall be returned
with repairs charged C.O.D. Allow 4 to 6 weeks for delivery.
Customer Service: 1-800-245-9265 or 1-408-963-4550
E-mail: info@zircon.com
Patent Pending
©2004 Zircon Corporation • P/N 59601 Rev C 09/04
DANGER
LASER RADIATION—DO NOT STARE INTO BEAM
OR VIEW DIRECTLY WITH OPTICAL INSTRUMENTS
Maximum Output Power < 5 mW @ 630–670 nm
CLASS llla LASER PRODUCT
This product conforms to Applicable Standards
of 21 CFR parts 1040.10 and 1040.11
INSTALLING THE BATTERY
Laser
Press battery door
Aperture
1
release with finger
and remove door.
Place 2 AAA batteries
2
in the compartment,
matching (+) and (-)
terminals from battery
to case.
Replace battery door and
3
snap shut. Batteries will
last approximately 2 years
under normal conditions.
i
Line can be used in
8
all four directions–up,
down, left, and right.
i
Line can be used as a line
9
generator for flooring and
counter tops.
Note: Unit will not level in
this orientation.
To turn off, close
10
cover completely.
Warning: Never shine laser spot
directly into eyes. The Class IIIa laser
can cause serious eye injury.
Press here
Up
Down
Left
Right