CONFIDENTIAL 1 Precautions Follow these safety, servicing and ESD precautions to prevent damage and to protect against potential hazards such as electrical shock. 1-1 Safety Precautions 1-1-1 Warnings For continued safety, do not attempt to modify the (READING SHOULD circuit board. NOT BE ABOVE 0.5mA) Disconnect the AC power and DC Power Jack before servicing.
Page 4
CONFIDENTIAL 1 Precautions 1-2 Servicing Precautions WARNING: An electrolytic capacitor installed with the wrong polarity might explode. Caution: Before servicing units covered by this service manual, read and follow the Safety Precautions section of this manual. Note: If unforeseen circumstances create conflict between the following servicing precautions and any of the safety precautions, always follow the safety precautions.
CONFIDENTIAL 2 Product Specifications 2-3 Timing Chart This section of the service manual describes the timing that the computer industry recognizes as standard for computer-generated video signals. Table 2-1. Timing Chart Mode VESA VGA2/ VGA3/ 640/75 Hz 640/85 Hz 800/75 Hz 800/85 Hz 1024/60Hz 1024/75Hz...
CONFIDENTIAL 3 Disassembly and Reassembly This section of the service manual describes the disassembly and reassembly procedures for the ES15N*/ES17N* monitor. WARNING: This monitor contains electrostatically sensitive devices. Use caution when handling these components. 3-1 Disassembly Cautions:1. Disconnect the monitor from the power source before disassembly. 2.
Page 10
CONFIDENTIAL 3 Disassembly and Reassembly 2. Push down the stopper and slide the lamp unit. 3. Please take out the lamp units from the LCD module. 4. Please fix the new lamp units on the LCD module : opposite process 2 and 3 Replacement of lamp unit should be done at the power off state and recommended clean bench condition.
CONFIDENTIAL 4 Alignments and Adjustments 4-1 General Alignment Instruction 1. Usually, a color TV-VCR needs only slight touch-up adjustment upon installation. Check the basic characteristics such as height, horizontal and vertical sync. 2. Use the specified test equipment or its equivalent. 3.
Page 12
CONFIDENTIAL 4 Alignments and Adjustments Memo ES15N*/ES17N*...
CONFIDENTIAL 5 Troubleshooting 5-1 No Power Does proper DC 14 V appear at Check SMPS PCB and Adapter. DC jack connected to CN801? Does proper DC 5 V appear at Check IC803. Pin 1 of IC803? Does proper DC 14V appear at Check IC803.
Page 14
CONFIDENTIAL 5 Troubleshooting 5-2 No Video (PC Signal) Power indicator is green. Does the signal appear at C106, C107, C108 Check CN100. of R, G, B input? Does the clock pulse Check X100 and related circuit of X100. appear at X100? Does the clock pulse appear at Check related circuit of IC102.
Page 15
CONFIDENTIAL 5 Troubleshooting 5-3 No Picture (TV, Video, S-Video, Scart Video) Check Pin 71, 72 (S-Video) and Pin 73 (VCR) and Pin 74 Check the CN806 (Tuner) and the and Pin 75 (RF-CVBS) CN802 (VCR connector). of IC201 (VPC3230D). Does the signal appear at Check the IC201 (VPC3230D) RA200 ~RA203? and related circuit of IC201.
Page 16
CONFIDENTIAL 5 Troubleshooting 5-4 No Sound Does the signal appear at Check the CN803 (PC conector) and the Pin 67 (Tuner sound signal) and CN802 (VCR connector) and the Pin 57, 56 (PC sound) and Pin 51, 50 CN200 the CN806 (Tuner). (VCR sound) of IC 700 (MSP3451)? Does the signal appear at Pin 27, Check the IC700 and...
Page 17
CONFIDENTIAL 6 Exploded View and Parts List 6-1 ES15N* ES15N*/ES17N*...
Page 61
CONFIDENTIAL 7 Electrical Parts List 7-2-2 Others Part Name Code No. Description Specification Remarks BN90-00195E ASSY STAND GH17LS STD+C/R 6001-000154 SCREW-MACHINE BH,+,M4,L8,NI PLT,SM20C,- BN75-00242A UNIT-STAND EOS 15AS/NS,-,ABS,-,SV-012P,-,SPRAY,- 6003-000009 SCREW-TAPTITE BH,+,B,M4,L16,ZPC(YEL),SWRCH18 6003-001315 SCREW-TAPTITE BH,+,B,M4,L20,ZPC(YEL),SWRCH18A BN72-00254A STAND COVER-REAR EOS 15,ABS,IV16,-,-,HB,-,-,SPRAY BN72-00256A STAND BASE EOS 15,AL T2.0,-,-,-,-,-,-,- BN72-00257A STAND FRONT...
Page 62
CONFIDENTIAL 7 Electrical Parts List Memo 7-44 ES15N*/ES17N*...
CONFIDENTIAL 9 Wiring Diagram KEY0 KEY1 KEY2 CN800 KEY3 CN600 CN601 KEY4 KEY5 KEY6 SPK OUT R + CN105 SPK OUT -R- SPK OUT L + CN104 SPK OUT L- CN804 AUDIO R IN AUDIO L IN VCR CVB S CN802 LED_GRN CHK_VIDEO...