Waterpik Water Flosser WP-260 Quick Start Manual
Hide thumbs Also See for Water Flosser WP-260:

Advertisement

1

Prepare the Reservoir:

Remove the reservoir from
Fill
base and fill with lukewarm
water.
Replace the reservoir onto the
PRESSING DOWN FIRMLY
base,
to ensure full seating.
3

Prime Unit (First Time Use Only):

Prior to Very First Use of Unit, Prime
Unit:
Set pressure control dial on base to
high,
point the handle and tip into sink.
Turn unit
ON
until water flows from the
tip. Turn unit
OFF.
O
I
High
2
1
3
This device is compatible with global voltages of 100 - 240VAC, 60/50Hz.
QUICK START GUIDE
Replace
O
I
2
1
3
2

Select and Insert Tip:

Press tip
firmly into
handle.
Insert
4

Adjust Pressure Control:

For first time users, adjust pressure
control to
lowest
position. Gradually
increase pressure to your liking.
O
I
Low
2
1
3
Model WP-260
NO
Gap
When tip is properly
inserted there should be
no gap between handle
and colored tip ring.
O
2
1
continued on back
3

Advertisement

Table of Contents
loading
Need help?

Need help?

Do you have a question about the Water Flosser WP-260 and is the answer not in the manual?

Questions and answers

Subscribe to Our Youtube Channel

Summary of Contents for Waterpik Water Flosser WP-260

  • Page 1 Model WP-260 QUICK START GUIDE Prepare the Reservoir: Select and Insert Tip: Press tip Remove the reservoir from Fill firmly into base and fill with lukewarm water. handle. Replace Insert When tip is properly inserted there should be Replace the reservoir onto the PRESSING DOWN FIRMLY no gap between handle base,...
  • Page 2 Using your Waterpik Water Flosser: ® Aim the water stream just above the Always place tip in mouth gumline at a 90 degree angle. before turning unit on. Lean over sink and close lips enough to prevent splashing, while still allowing water to flow from mouth into the sink.

Table of Contents