Table of Contents
Advertisement
QQ
3 7 63 1515 0
3.1.8 Removing the rear bracket
(See Fig.13)
• Prior to performing the following procedures, remove the front
panel assembly, heat sink, top chassis assembly and main
board.
(1) From the rear side of the main board, remove the wire from
the rear bracket in the direction of the arrow.
(2) Remove the two screws K and three screws L attaching the
rear bracket to the main board.
Reference:
After attaching the rear bracket to the main board, pass
the wire through the wire holder and insert them into the
slot of the rear bracket.
3.1.9 Removing the front door mechanism assembly
(See Fig.14.)
• Prior to performing the following procedures, remove the front
panel assembly, heat sink, top chassis assembly and main
board.
(1) From the top side of the bottom chassis assembly, remove
the screw M attaching the shaft holder to the bottom chas-
sis.
TE
L 13942296513
(2) Remove the five screws N attaching the front door mecha-
nism assembly to the bottom chassis.
Reference:
When attaching the screws M and N, apply a locking
agent them.
(3) Take out the front door mechanism assembly from the bot-
tom chassis.
www
.
1-10 (No.MA049)
http://www.xiaoyu163.com
x
ao
u163
y
i
http://www.xiaoyu163.com
2 9
8
Wire
Rear bracket
K
L
K
Front door mechanism assembly
Bottom chassis
Q Q
3
6 7
1 3
1 5
N
Shaft holder
co
.
9 4
2 8
Main board
Wire holde
Slot
Rear bracket
L
Fig.13
0 5
8
2 9
9 4
2 8
N
M
Fig.14
m
9 9
9 9
Advertisement
Chapters
Table of Contents
