Table of Contents
Advertisement
LAMP REPLACEMENT
Attention! When replacing the lamp is important not to touch lamp with bare hands, to avoid
greasy dirt stains on the filament which degrades performance and lamp life. Disconnect the
power. Before replacing the lamp the fixture needs 20 minutes for lamp cooling. Fasten the head
with Y axis protect lock in 60 ° position.
1. Use cross screwdriver to open the light body cover (picture 1)
（1）
2. After open the cover,you can see the lamp inside,please wait the lamp be cool after used but not
touch it in hot status.(picture 2)
（2）
3. One hand press the lamp holder,another hand hold the lamp,and pull out the wires(picture 3,4)
（3）
（4）
4.after take apart the lamp, please check the inside glasses, clear it will make the light better
effect.(Picture 5)
（5）
5.install the lamp after replaced.
8
Advertisement
Table of Contents
