Table of Contents
Advertisement
4.6
TO PREVENT BURNING OR FIRE
1.
The fixture can be mounted directly on the surface of ordinary combustible material.
2.
Do not short-circuit temperature protection switch or fuse, use the specified type of fuse.
3.
The equipment must be installed away from inflammable and explosive materials.
4.
The equipment should be at a projected range of 15 meters away objects and projectiles
5. Keep obstacles al least 0.5m away from the
6.
Do not place any object on the lens.
7. Allow 20 minutes for the lantern to cool before h
8.
Do not replace parts with non-original parts & consult your dealer before attempting
repairs.
4.7
TRANSPORT PROTECT LOCK
In order to protect the light, there is a transport lock; During transport the lock catch should
be positioned in the center to keep the fixture head in a vertical state.
ABOUT PACKING
4.8
1. Before packing away, make sure power is off, and wait for at least 20 minutes for the fixture
to cool down.
2. Before cleaning the fixture, make sure X, Y axis transport lock is closed.
3. Lift the unit only by the two side grab handles and turn fixture upside down and then place
in the flight case.
4. After packed, put accessory into the accessory case, then close and lock the flight case.
5. Flight cases should only be stacked two high and never upside down
UNPACKING
4.9
1. Open the flight casee, and lift out the fixture using the 2 side grab handles.
2. Turn fixture over and place on a stable surface with enough space for the head to turn
through 360 degrees.
3. Before power up, make sure you have opened the X, Y axis lock!
Attention!
Two omega clamps must be attached to the fixture for hanging together with suitable
hook clamps. Omega clamps have a 1/4 turn lock, fully clockwise rotate 90 ° to lock them in
place. Add one safety bond on the hole of light base as additional insurance against clamp
failure.
Attention! Each fixture can only accept one DMX input & output.
Do not use two outputs to separate or split the DMX connection, if a separate branch is required a
DMX512 splitter is necessary.
It is therefore not recommended to change from 3 pin to 5 pin
DMX connections using the head itself as signal loss can occur.
Fans or ventilation slots.
andling
6
Advertisement
Table of Contents
