Panasonic LC4.8E AA Service Manual page 9

Chassis
Table of Contents

Advertisement

www.freeservicemanuals.info
The aluminium stands (order code 3122 785 90480) can be
mounted with the back cover removed or still left on. So, the
stand can be used to store products or to do measurements. It
is also very suitable to perform duration tests without taking
much space, without having the risk of overheating, or the risk
of products falling. The stands can be mounted and removed
quick and easy with use of the delivered screws that can be
tightened and loosened manually without the use of tools. See
figure above.
Note: Only use the delivered screws to mount the monitor to
the stands.
4.3
Assy/Panel Removal
4.3.1
Rear Cover
3
4
3
3
4
3
Figure 4-4 Rear cover
Warning: Disconnect the mains power cord before you remove
the rear cover.
1. Remove the screws that secure the rear cover (see Figure
"Rear cover screws"); these are:
a) 4 x big torx screws (1) for securing the stand/wall mount;
b) 5 x small torx screws (2) near the rear I/O panel;
c) 22 x small torx screws (3) that secure the loudspeaker
compartments [6 of these screws are in sunken holes (4) ]
and along the edges of the rear cover.
2. Lift the rear cover from the cabinet cautiously. Make sure
that wires and other internal components are not damaged
during cover removal.
Mechanical Instructions
3
3
4
3
1
2
3
4
3
F_15420_034.eps
070605
LC4.8E AA
4.3.2
Side I/O Panel
Figure 4-5 Side I/O panel
1. Disconnect the cable (1) from the panel.
2. Remove the fixation screw (2) and lift the panel out of its
brackets.
4.
EN 9
2
1
F_15420_035.eps
070605

Advertisement

Table of Contents
loading

Table of Contents