Baofeng BF-F9V2+ Operating Manual page 59

a A O F E N E
www.baofengradio.us
http://www.baofengradlo.us
www.foscam.us
Menu Definitions
Menu Item
BAND
Shortcut
33
Description
BAND Selection: In VFO/Frequency mode, sets [A] or [B]
to the VHF or UHF band.
Availability: Availability: MR/Channel Mode (Read Only), VFO/Frequency Mode,
Separate VFO A & B Settings, Stored in Channel
Settings/Notes
VHF [0] | UHF [1] Default: VHF Note: When transitioning from VHF to UHF or from
UHF to VHF, the selected band's low frequency limit becomes the displayed frequency
(the original 'scratch' frequency is lost)
Menu Item
TDR-AB
Shortcut
34
Description
Transceiver Dual Reception - [A]/[B] Display Priority: When
enabled, priority is returned to selected display once the signal
in the other display disappears.
Availability: Global
Settings/Notes
OFF[0] | A [1] | B [2] Default: OFF Note: Requires menu item 7 to be enabled
Menu Item
STE
Shortcut
3 5
Description
Transceiver - Squelch Tail Elimination: This function is used
eliminate squelch tail noise between BF-F9V2+S that are
communicating directly (no repeater). Reception of a 55 Hz
or 134.4 Hz tone burst mutes the audio long enough to prevent
hearing any squelch tail noise.
Availability: Global
Settings/Notes
OFF [0] | ON [1] Default: ON
Note: When enabled and T-DCS is set to OFF the radio sends a 55 Hz tone for about
1/4 second when the PTT button is released.
Note: When enabled and T-DCS is not set to OFF the radio sends a 134.4 Hz tone for
about 1/4 second when the PTT button is released.
Note: Set to OFF before communicating through a repeater.
Note: Recommended setting is OFF.
59