Download Print this page

GADLEE GT50 B50 Quick Manual

Advertisement

Quick Links

This Guide is intended for quick consultation only and does not replace the Use and Maintenance Manual.   
Before using the machine, read the Use and Maintenance Manual contained in the machine packaging thoroughly and 
rigorously respect all the instructions. 
 
PREPARATION/ OPERATION 
1. Fill the detergent tank. 
 
2. Lower  the  machine  head  by 
pressing  the  pedal  downwards 
and to the left.       
Pedal command 
Brush Head 
 
up 
3. Open the detergent tank tap. 
 
4. Press the brush button. 
5. Lower  the  squeegee  using  the 
lever, 
vacuum 
motor 
automatic. 
 
 
 
 
 
http://www.gadlee.com email: info@gadlee.com    Toll‐Free:4008‐833‐830 
GT50 B50 Quick Guide 
6. Operate the drive lever. 
7. Begin working. 
8. When you have finished cleaning, 
proceed as follows:: 
Brush head 
Turn the brush motor off. 
down 
Raise the machine head. 
Raise the squeegee. 
Close the detergent tank tap. 
If necessary, charge the 
batteries. 
 
DAILY MAINTENANCE     
start 
Empty the dirty water drum through 
the drain hose.         
 
Clean the dirty water drum. 
 
Check the suction filter is undamaged 
and clean.   
 
Check the detergent tank fill filter is 
undamaged and clean.     
Check the detergent output filter is 
undamaged and clean.     
Clean the brush. 
 
 
 
 
 

Advertisement

loading
Need help?

Need help?

Do you have a question about the GT50 B50 and is the answer not in the manual?

Questions and answers

Subscribe to Our Youtube Channel

Summary of Contents for GADLEE GT50 B50

  • Page 1     4. Press the brush button.  Check the detergent output filter is  undamaged and clean.        5. Lower  the  squeegee  using  the  DAILY MAINTENANCE      lever,  vacuum  motor  start    automatic.  Empty the dirty water drum through  Clean the brush.  the drain hose.                      http://www.gadlee.com email: info@gadlee.com    Toll‐Free:4008‐833‐830 ...
  • Page 2 Attaching the brush: rest the brush on the floor in front of the machine and centre it with the guard.    Lower the head and operate the  brush/drive lever repeatedly until the brush automatically engages on the flange hub.    If the operation is not successful, repeat by pressing on  the lever again and repeating the centring.  Removing the brush: raise the machine head by pushing the head lift pedal down and then to the right and operate the brush/drive lever  repeatedly.    After operating the lever a few times, the brush is released and falls to the ground.  TROUBLE SHOOTING  THE MACHINE DOES NOT COME ON/START UP  CHECK THE BATTERY CHARGER  CHECK THE DIRTY WATER DRUM IS NOT FULL  THE SUCTION MOTOR DOES NOT WORK  CHECK THE DIRTY WATER DRUM LEVEL SENSOR IS NOT  BLOCKED/MALFUNCTIONING  CHECK THE SQUEEGEE BLADES ARE NOT WORN  CHECK THERE IS NO DEBRIS BETWEEN THE TWO SQUEEGEE BLADES  CHECK THERE IS NO DEBRIS IN THE SUCTION HOSE  THE MACHINE LEAVES THE FLOOR WET  CHECK THE SUCTION FILTER IS UNDAMAGED AND CLEAN  CHECK THE DETERGENT TANK LID IS CLOSED CORRECTLY  CHECK THE SUCTION HOSE IS CORRECTLY ATTACHED TO THE SQUEEGEE  CHECK THE TYPE OF BRUSH/PAD IN USE IS SUITABLE FOR THE TYPE OF DIRT AND  THE MACHINE LEAVES THE FLOOR DIRTY  FLOOR.      CHECK THE FLOOR HAS BEEN BRUSHED BEFORE USING THE MACHINE  CHECK THERE IS NO DEBRIS BETWEEN THE TWO SQUEEGEE BLADES  THE MACHINE LEAVES STRIPES OF WET FLOOR  CHECK THE SQUEEGEE BLADES ARE NOT WORN  CHECK THE SQUEEGEE IS CORRECTLY ADJUSTED        http://www.gadlee.com email: info@gadlee.com    Toll‐Free:4008‐833‐830   ...