1. INTRODUCTION Audiophile Circuits League . -QLFO is generating an sine wave and 3 phase-shifted copies of it by 90° (cosine), 180° (inverted sine) and 270° (inverted cosine). The frequency of the LFO can be voltage controlled, the CV input is attenuverted.
2. WARRANTY Is it a malfunction? In the event of a fault in use, we will repair or replace it free of charge under the warranty terms stated below. The warranty period is valid for one year from the Please read the user's manual carefully and check again. If you think that there is day of purchase.
3. INSTALLATION WARNING *Always turn the Eurorack unit off and unplug the power cord before pluging GATE the Eurorack power cable. *When attaching the Eurorack power cable, please be careful not to touch the terminal part. +12V Connect to the Eurorack's system power supply (+ 12V) using the supplied Eurorack power cable.
4. FUNCTION OF PANEL COMPONENTS ① "RATE" knob Adjust the speed of the LFO. The range covers frequencies from a fraction of 1 Hz to to more than 20kHz. ② "DEPTH" knob This is the attenuverter for the input level of the CV signal from the ④ "RATE CV"...
Page 7
⑧ "INV/SIN" output jack (inverted sine wave) Inverted Sine wave output. (sine wave shifted by 180 degrees) INV/SIN ⑨ "INV/COSIN" output jack (inverted cosine wave) (180) Inverted cosine wave output. (sine wave shifted by 270 degrees) COSIN INV/COSIN (90) (270) FIG.3 :...
Eurorack system power supply Width 8 HP Depth 22 mm Power consumption On -12V: varying dependent on frequency; ca. 12-28 mA On +12V: varying dependent on frequency; ca. 12-28 mA Accessories · Eurorack power cable x1 · Mounting screws x2 ACL-E-LFO-1709-1...
Need help?
Do you have a question about the QLFO and is the answer not in the manual?
Questions and answers