Operation And Start-Up; Bluetooth © Connection; Changing The Cartridge - BC Acoustique TD922 Owner's Manual

Operation and start-up

AT THE FRONT OF THE TURNTABLE
-18- Place a record on the turntable platter. When playing a 45
RPM large-hole single record, use the included adapter. Select
the rotation speed indicated on the record (33, 45 or 78 RPM).
-19- Slide the tone arm lock clasp to the right to release the
tone arm.
-20- Move the tone arms to the track where you want to start
playback.
This operation can be done manually or, as we advise you,
use the arm lifter and the slowly lower the tone arm to start
playback.
IMPORTANT Notes
- During the playback do not touch the tone arm or the record
as you may damage the stylus or cause scratches on the
record.
- Do not force the platter to stop rotating during playback as this
may cause malfunctions.
This turntable is NOT designed for DJs who use direct drive
turntables.
-21- ANTISKATING ADJUSTMENT
To start, set the antiskating wheel at position 2, then during
playbak, try the other positions until you find, by listening to,
the right balance between the right and left channel volumes.
Bluetooth
This turntable integrates a Bluetooth
music to your actives speakers wirelessly.
-1- Turn on the turntable POWER ON.
The switch is located on the back of the unit.
-2- On the right side of the turntable a blue led starts to blink.
It indicates that it sends a connection request.
You should be able to see on your Bluetooth® speakers or hi-fi
system the connection name of the deck that is: «BC-TD-922.»
-3- When the turntable and the Bluetooth® speaker is connected,
the pairing lamp will stay lit without blinking.
Pairing might take some time depending on the connected
device.
Refer to the operation manual of the Bluetooth®
speaker for information about how to use it.
When connecting to a Bluetooth® speaker, move other
Bluetooth® speakers and receiving devices at least 10 meters
away from this unit or turn them off.
-4- Press the BT button to send music or pause it.
-5- To turn off Bluetooth
©
during 3 seconds. The led on the right side of the turntable will
go off when the Bluetooth
©
connection
©
transmitter to send
©
connection, press the BT button
connection is disabled.

Changing the cartridge

To change the cartridge, first remove the headshell from the
tone arm. Remember to attach the protective cap to protect the
stylus cartridge during this operation.
An Audio Technica AT-3600 L type cartridge is installed in this
turntable.
Compatibiliy:
VM type cartridges have the same characteristics as MM type
cartridges.
-1- Disconnect the shell lead terminals from the cartridge.
① Nuts
② Headshell
③ Screws
④ Cartridge
⑤ Shell leads
-2- Loosen the screws and remove the cartridge.
-3- Attach the new cartridge and tighten the screws.
See the illustration below for he position of the screws when
attached.
-4- Connect the shell lead terminals to the cartridge.
Signal
Left Chanel +
Left Chanel -
Right Chanel +
Right Chanel -
-5- Once the balance done, Attach the headshell by inserting it
into the front end of the tone arm and then turn the locking nut
clockwise.
-6- Balance the tone arm and adjust the stylus pressure.
Follow this procedure on page 6 in «-6- Balancing the tone arm
and adjusting the stylus pressure».
7
Color
White
Blue
Red
Green