ZappBug Heater Owner's Manual page 7

Use & Operation
Thermometer Base Station Set Up
1. Remove the battery door on the back of the base station, shown in Figure 1
image below.
2. Insert one AA battery. All of the LCD segments will light up for a few seconds
to verify all segments are operating properly.
3. The thermometer base station will instantly display the ambient temperature.
The probe temperatures will update on the display within a few minutes after
you place batteries in probe.(see Thermometer Probe Setup on page 13)
1
2
Figure 1
1
2
Figure 2
©2014-2018 ZappBug. All rights reserved. Product specifications subject to change.
(continued)
Figure 1
1. Battery Compartment
2. Stand Mount
IMPORTANT: Insert batteries and
Setup Thermometer Base Station first
Figure 2
1. Time
2. Ambient Room Temperature
3
3. Reception Icon
4. ZappBug Sensor Temperature
4
Use & Operation
Thermometer Probe Set Up
1
2
3
1. Remove the battery door on the back of the thermometer probe by sliding
the door down and insert one AA battery.
2. After inserting the battery, the remote sensor LED indicator will light for 4
seconds, and then flash once per 60secs thereafter. Each time it flashes, the
sensor is transmitting data.
3. Close battery door. While in search mode, the reception icon will flash
on the thermometer base station.
4. Place the wireless thermometer probe in the deepest (most insulated) part
of your luggage (or item begin treated) and allow the ZappBug Heater
run for 60 minutes or longer after the temperature reaches 120
locations.
5. If you are not present while the unit is running we advise setting the timers to
8 hours, however this is generally more time than required for the ZappBug
Heater to reach 120 F and maintain it for one hour.
TM o
6. If the base station does not update, view troubleshooting tips on page 18
(continued)
Thermometer Probe
1. Wireless Transmitter LED
2. AA Battery
3. Battery Compartment Cover
F in all three
o
To learn more, please visit us at ZappBug.com
to
TM
13