Subscribe to Our Youtube Channel
Related Manuals for Comelit IPCAM742B
Summary of Contents for Comelit IPCAM742B
- Page 1 FULL-HD BOX IP CAMERA ART. IPCAM742B Please read this guide thoroughly before use and keep it handy for future reference.
- Page 3 1 Introduction The network camera supports the network service for a sensor image with progressive scan, which can be monitored on a real-time screen regardless of distances and locations. By using its dedicated program, many users are able to have an access to the network camera at once or a single user can monitor various network cameras at the same time.
-
Page 4: Installation
2 Installation 2.1 Basic Configuration of Camera System The camera must be installed by qualified service personnel in accordance with all local and federal electrical and building codes. • Rear View Connector Description 12VDC + 2-pin terminal block 12VDC- Alarm input 3-pin terminal block Alarm output Stereo jack... - Page 5 • LED Indicators Color Indication Status Steady red for failed upgrade or booting. Steady green for normal operation or booting. Power Green Flashes green during firmware upgrade. Note: Steady green and red during booting. Flash green and red during factory default. •...
-
Page 6: Camera Adjustment
2.2 Camera Adjustment 1) DC auto IRIS lens installation & adjustment Solder the lens control wires to the connector supplied with the camera. Name Wire Color Damp Coil - Blue Damp Coil + Drive Coil + White Drive Coil - Green Attach the DC-type auto iris lens to the lens mount on the front of the camera. - Page 7 2.3 Connections • Connecting the Network Connect a standard RJ-45 cable to the network port of the camera. Generally a crossover cable is used for directly connection to PC, while a direct cable is used for connection to a hub. •...
-
Page 8: Network Connection & Ip Assignment
2.4. Network Connection & IP assignment The camera supports the operation through the network. When a camera is first connected to the network, it is necessary to allocate an IP address to the device with the SmartManager utility on the CD (default IP 192.168.30.220). 1) Connect the network camera/device to the network and power up. -
Page 9: Resetting To The Factory Default Settings
2.5 Resetting to the factory default settings To reset the network camera to the original factory settings, go to the Setup > System > Maintenance web page (described in “System > Maintenance” of User’s Manual) or use the Reset button on the network camera, as described below: •... -
Page 10: Product Specification
A Appendix PRODUCT SPECIFICATION Type 1/2.9” SONY Exmor CMOS sensor Image Sensor Pixels 1920 (H) x 1080 (V) Min. Illumination Color : 0.2Lux, B/W : 0.01Lux(F1.2, 50IRE) Scanning Mode Progressive Scan Wide Dynamic Range D-WDR (72dB) Day and Night Mode True D/N (Auto, Day, Night) Noise Reduction 2DNR, 3DNR... - Page 11 NETWORK TCP/IP, UDP, IPv4/v6, HTTP, HTTPS, QoS, FTP, UPnP, Protocols RTP, RTSP, RTCP, DHCP, ARP, Zeroconf, Bonjour Client Software Web, SmartManager, Client S/W, Mobile S/W Max. User Connection Live: 10 Users, Playback: 3 Users API Support Open API, ONVIF Compliance Mobile Support Android, i-OS EXTERNAL IN/OUT...
- Page 12 w w w . c o m e l i t g r o u p . c o m...
Need help?
Do you have a question about the IPCAM742B and is the answer not in the manual?
Questions and answers