Table of Contents
Advertisement
8
Getting Started
Charging the Unit
Connecting the AC adapter
1
This device uses built-in battery. Before using it,
charge the battery by connecting the AC Adapter.
1. Connect the supplied AC power cord to the AC
adapter.
2. Connect the AC adapter cable to DC IN adapter
input.
3. Plug the AC power cord into an AC outlet.
AC Adapter
>
Caution
Only use the AC adapter supplied with this
device. Do not use a power supply from
another device or manufacturer. Using any
other power cable or power supply may cause
damage to the device and void your warranty.
NP6530-B0.BPOLLLK_ENG_MFL67789511.indd 8
Checking the charging status
When AC Adapter is connected, battery charging
is started. You can check the charging status with
1/! button. (Refer to the page 17 for details)
y Charging : The 1/! button blinks red or white.
y Fully charged : The 1/! button turns red or
white.
,
Operating time is approx. 10 hours. (Based on
30% volume, 1kHz signal, 500 mV portable
input and fully charged status)
It may vary depending on the battery status
and operational conditions.
Battery protection
If AC adapter is connected and the unit is in high
AC power cord
or low temperature, the battery may not function
properly. Please reference the table below to fully
understand the battery protection feature.
In this case, use the unit in proper place where the
temperature or humidity is not so high or low.
Power
Off
Power
On
Note
Battery temperature : Very low
(Red) (White)
Battery temperature : Very High
(Red) (White) (Off )
Warning
Blinks
10 sec
2013-11-12
6:09:30
Advertisement
Table of Contents
