Remote Control - Blue Ridge DTA Mini Box Important Safety Instructions Manual

Remote Control

Program your remote to control your TV functions.
Your remote control is already programmed to control your DTA Mini Box. To control your TV functions
(TV Input, TV Power, VOL+, VOL- and Mute), follow the steps below:
1. Install the batteries (see left).
2. Find the manufacturer's code for your TV
NOTE
(see pamphlet packaged with the remote).
3. Turn on your TV and DTA Mini Box.
• When inserting
4. On your remote, press and hold the Setup
batteries, make sure
button until the Indicator LED changes from
that the polarity (+/-)
red to green.
is correct.
5. Enter the first manufacturer's code you
• The LED on the top of
found in Step 2. The Indicator LED will flash
the remote is a visual
green twice.
indicator that confirms
6. Press the TV Power button on the remote
the remote has
control. If the TV turns off, you know the code
power when a button
has been accepted. Turn the TV back on and
is pressed.
make sure that the VOL+/- and Mute buttons
• Your remote may vary
also work. If so, you're all set!
slightly from the one
7. If not, repeat these steps using the next
pictured here.
manufacturer's code found in Step 2. (You
However, basic
may need to try several codes to find the one
functions should
remain the same.
that works for your TV). If you still can't find a
code that works, see "Can't Find Your Code?"
at right.
5
Can't Find Your Code?
If you can't program your remote using the
codes in the pamphlet, follow the steps below
to search for your code.
1. Turn on your TV.
2. On your remote, press and hold the Setup
button until the Indicator LED changes from
red to green.
3. Enter A.
4. Press the CH^ button multiple times until the
TV turns off.
5. After the TV turns off, press Setup.
6. Successful TV IR code storage is indicated
by 2 green blinks.
Installing your DTA Mini Box out of sight (pair remote) ê
Your remote control can be paired directly with your DTA Mini Box, allowing you to place the de-
vice out of sight (in an entertainment center or behind your TV, for example). Once your remote is
paired to a specific DTA Mini Box, it will not control any other set-top box in your home.
Pair your remote control with your DTA Mini Box
1. Press the Menu button.
2. Select Remote Control and then select
Remote Control Pairing.
3. Press and hold Setup button until the
LED Indicator turns green.
4. Press the Menu button.
Please allow a few seconds for the menu to display
5. Proceed by entering the pairing code displayed
in blue on the pairing code pop-up screen.
Note: If you don't see a pairing code screen, repeat steps 1 and 2.
To force remote control to send volume To force remote control to send volume
control commands to the TV control commands to the DTA Mini Box
1. Press and hold Setup button until the 1. Press and hold Setup button until the
LED Indicator turns green.
2. Press the volume up button 2. Press the volume down button
Note: Refer to the Remote Control Programming and Operating instructions, provided with your remote control, to program your remote to
work on your TV and for more detailed information regarding pairing your remote.
Remote Control
Remove remote
control pairing
If you would like to
use your remote
control for a different
set-top box, you
must first un-pair
the remote control
from the current
device. Follow the
steps below to
remove the pairing.
1 Press and hold the
Setup button until
the LED Indicator
turns green.
2 Enter 9-8-7 on the
LED Indicator turns green.
remote control.
3 The LED Indicator will
blink green twice.
6