Licensing Configuration - Sencore TSS 6220 User Manual

Configure Networks and Configure Network Port Settings
Setting Range
Hostname Valid characters:
A through Z
0 through 9
- (hyphen)
Default Gateway Lists the available
Ethernet ports, Eth0,
Eth1, etc. for
selection
Nameserver Four decimal octets
XXX.XXX.XXX.XXX
Mode DHCP
Static
IP Four decimal octets:
XXX.XXX.XXX.XXX
255.0.0.0 –
Subnet Mask
255.255.255.254
Gateway Four decimal octets:
XXX.XXX.XXX.XXX

10.10 Licensing Configuration

Features of the TSS 6220 require a license in order to be functional. Licensing information is
shown in the web GUI within the Admin tab and License Information section. This section also
provides license management in which new licensing may be applied to add features.
The License Information section displays all licenses which are available as well as the following
status regarding the listings. Note: The Disaster Recovery feature is currently under development.
•
License Status: Locked or Unlocked
Page 113 (123)
TSS 6220 – User Manual
Description
This setting allows the user to define an optional
unit Hostname.
Selects the network interface to use as the network
gateway
Allows entry of a primary and a secondary
nameserver IP address. To disable set to 0.0.0.0
Setting to DHCP will allow the network assign an IP
address automatically to the TSS 6220 (if
supported). Setting to Static allows the user to
manually define all TCP/IP settings for the
management port.
This option is only available if Static Mode is set.
This is the IP address assigned to the management
port.
This option is only available if Static Mode is set.
This is the Subnet Mask assigned to the
management port.
This option is only available if Static Mode is set.
This is the Gateway address assigned to the
management port.