Network Setup; Authentication - Samsung SCX-6555NX Series User Manual

NETWORK SETUP

You may set up the network with the machine's touch screen. Before doing
that, you must have the information concerning the type of network
protocols and computer system you use. If you are not sure which setting to
use, contact your network administrator to configure this machine network.
1. Press Machine Setup on the control panel.
2. Press Admin Setting. When the login message pops up, enter
password and press OK.
3. Press the Setup tab > Network Setup.
OPTION
TCP/IP Protocol Select appropriate protocol and configure
parameters to use the network environment.
There are lots of parameters to be set,
therefore, if you are not sure, leave as it is,
or consult the network administrator.
Ethernet Speed Configure the network transmission speed.
Clear Setting Reverts the network settings to the default values.
802.1x You can select the user authentication for network
communication.
For details information consult the network admin-
istrator.
IPv6 Selects this option to use the network environment
through IPv6.
DESCRIPTION

AUTHENTICATION

This feature lets you control and lock all outgoing data, or change the
password.
1. Press Machine Setup on the control panel.
2. Press Admin Setting. When the login message pops up, then enter
password and press OK.
3. Press the Setup tab > Authentication.
OPTION OPTION
Authentication No
Mode Authentication
Mode
Network
Accounting
Standard
Accounting
Foreign Device
Interface
80
DESCRIPTION
It disables Authentication Mode.
It enables the authentication mode
which can be used for Job
Accounting Plug-in the
SyncThru™ Web Admin Service.
You can set the local account for a
certain user. If the user with that
account performs the printing job,
the machine counts it.
When you install the optional FDI
kit, select Foreign Device
Interface Configuration Setup to
activate it.
• Job Timer: If there is not
enough credit, you can set the
machine to cancel a job right
away or wait a designated
amount of time for a deposit.
• Print Job Control: When it is
enabled, the both computer
printing and copying are
possible since the credit
remains. With Disable, only
the copy printing job needs the
credit. (which means a
computer printing a report or a
fax job needs no credits)
• Inhibit Services: When no
credit is left, the machine
disables the copy job only with
Copy Only. With All Services,
scanning service and copy job
are disabled.