Advertisement
Quick Links
Commissioning
• Push the labelled male and female connectors
together to power the demister pad.
• Refit the mirror front onto the wall back. Ensure that
the seals are correctly located before securing with
the four screws.
Shaver Socket Instructions
• The shaver socket is powered by a 20W isolating
transformer and is only intended for use with electric
shavers, electric toothbrush chargers and similar
products.
• Any appliance connected to the socket must not
exceed the 20W power output as this could cause
damage and overheating to occur.
Demister Operation
• Simply turn on the demister switch on the side. The
demister pad will warm the mirror surface.
• We recommend cleaning with a soft dry cloth. Do
not use solvents or abrasive cleaners as these could
damage the finish.
Recycling advice
Waste electrical products should not be disposed of with household waste. Please recycle where facilities
exist. Check with your Local Authority or retailer for recycling advice.
Safety information
Live Voltages may be present in this unit even when turned of or when completely disconnected. For your safety,
always switch off the supply before changing lightbulbs, or cleaning.
The mirror must be replaced immediately should it become cracked or damaged. This fitting must
not be used without the mirror in place.
www.saxbylighting.com
• Replace fuse or circuit breaker and switch on. Your
light is now ready for use.
• Activate your new LED mirror by swiping your hand in
front of the sensor.
• Always check your appliance instructions to ensure
the power requirements are less than 20W.
• The demisting effect will spread approximately 10 -
20% further than the pad itself.
• Mirror – Use a damp cloth or a propriety glass
cleaner. Do not use abrasive materials as these will
damage the finish.
Iss.1 08072015
Saxby Lighting BH23 3PE
Instruction leaflet
Rift Mirror
60895
Advertisement
Subscribe to Our Youtube Channel
Related Manuals for Saxby 60895
Summary of Contents for Saxby 60895
-
Page 1: Safety Information
Rift Mirror • Refit the mirror front onto the wall back. Ensure that • Activate your new LED mirror by swiping your hand in the seals are correctly located before securing with front of the sensor. the four screws. 60895 Shaver Socket Instructions • The shaver socket is powered by a 20W isolating • Always check your appliance instructions to ensure transformer and is only intended for use with electric the power requirements are less than 20W. - Page 2 This product is suitable for use in Zone Thank you for purchasing this light fitting. Please read the instructions carefully before use to ensure safe and 2 and outside Zones of a bathroom. satisfactory operation of this product. Please retain these instructions for future reference. See diagram. If this unit is being fitted in a room containing a bath or shower, a 30mA RCD must be used, Warning in accordance with IEE regulations. This is a Class 1 product and must be earthed This system contains non-replaceable parts and cannot be serviced. If damage occurs the part should Please read these instructions carefully before be scrapped. commencing any work. This product is not suitable for dimming. This unit must be fitted by a competent and qualified electrician. This product is rated at IP44. Install in accordance with IEE Wiring regulations and This product contains a demister pad. If this pad is current Building Regulations. damaged in anyway then it should be replaced by a qualified electrician. To prevent electrocution switch off at mains supply Installation before installing or maintaining this fitting. Ensure Waste electrical products should not be disposed of other persons cannot restore the electrical supply with household waste. Please recycle where facilities Existing fittings must be completely removed before • Ensure the wall is capable of holding the weight of the without your knowledge.
Need help?
Do you have a question about the 60895 and is the answer not in the manual?
Questions and answers