This section lists all the commands available for managing your storage enclosure.
Commands listed on the basis of command type
Topics:
•
Drive commands
•
List commands
•
Informational commands
Drive commands
Blink drive
Description
Helps visually locate the specified SCSI device by initiating a blink, or ending an existing blink session.
Command syntax
shmcli (blink drive | blinkdrive | bd) (-a=<(SAS WWID | AdapterIndex)> [-enc=<(WWN |
EnclIndex)> [-w=<DrawerIndex>]] -d=<(WWN | EnclosureSlotIndex | DrawerSlotIndex | Serial Number
| Drive OS Path)> [-off] | -d=<(WWN | Serial Number | Drive OS Path)> [-off] | [-h])
Parameters
Table 4. Drive commands
Parameter
-a
-enc
-w
-d
Description
Specifies the adapter to use for the command. This can be either
SASAddress or AdapterIndex.
Specifies the enclosure to use for the command. This is either
WWN or EnclIndex.
Specifies the drawer index used for the command.
Specifies the drive used for the command. This can be any of the
following:
•
WWN — Can be used anytime.
CLI reference
CLI reference
6
21