Advertisement
INSTALLATION INSTRUCTIONS
2700 - Gemini Mechanical
The 2700 lock can be installed in two ways:
- Surface Mount (accessory kit 951700_)
- Flush Mount (accessory kit 951600_)
Surface Mount
Step 1
Remove all packaging.
Step 2
Fit the surface mount sleeve to lock as shown in Picture 1.
Step 3
Position the lock on the outside of the door as shown in Picture 2.
Step 4
Holding the lock in position, fit the 2 x M4 pan head screws
(supplied with the surface mount sleeve) as shown in Picture 3.
Step 5
Tighten the 2 x M4 screws using a No.2 Posidriv
®
Step 6
Position the cam onto the rear of the lock as required, fit the cam
washer and fixing screw as shown in Picture 6.
Step 7
Tighten the cam fixing screw using a No.2 Posidriv
Take care not to damage the screw thread when fitting the screw.
Step 8
Before closing the door, test the lock by selecting the correct
User Code and rotating 90°.
Step 9
Your lock should now be ready to use.
Flush Mount
Step 1
Remove all packaging.
Step 2
Position the lock on the outside of the door as shown in Picture 4.
Step 3
Holding the lock in position, fit the clamp box and 2 x M4 pan head
screws (supplied with the clamp box) as shown in Picture 5.
Step 4
Tighten the 2 x M4 screws using a No.2 Posidriv
®
Step 5
Position the cam onto the rear of the lock as required, fit the cam
washer and fixing screw as shown in Picture 6.
Step 6
Tighten the cam fixing screw using a No.2 Posidriv
Take care not to damage the screw thread when fitting the screw.
Step 7
Before closing the door, test the lock by selecting the correct
User Code and rotating 90°.
Step 8
Your lock should now be ready to use.
Picture 1.
Fit surface mount sleeve to lock as shown.
to 1Nm.
to 1.5Nm.
®
to 1Nm.
®
to 1.5Nm.
Picture 2.
Position lock on door panel as shown.
Picture 3.
Fit 2 x M4 pan head screws as shown.
Picture 4.
Position lock through door panel as shown.
Picture 5.
Fit clamp box and 2 x M4 pan head screws as shown.
Picture 6.
Fit cam, washer & screw. Tighten with No.2 Posidriv
®
.
Advertisement
