Makita DHR280 Instruction Manual page 14

Dust cup
Optional accessory
Use the dust cup to prevent dust from falling over the
tool and on yourself when performing overhead drilling
operations. Attach the dust cup to the bit as shown in
the figure. The size of bits which the dust cup can be
attached to is as follows.
Model
Dust cup 5
Dust cup 9
► 1 . Dust cup
Dust cup set
Optional accessory
Before installing the dust cup set, remove the bit from
the tool if installed.
Install the dust cup set on the tool so that the
bol on the dust cup is aligned with the groove in the tool.
► 1 .
symbol 2. Groove
NOTE: If you connect a vacuum cleaner to the dust
cup set, remove the dust cap before connecting it.
Bit diameter
6 mm - 14.5 mm
12 mm - 16 mm
1
sym-
1
2
1
► 1 . Dust cap
To remove the dust cup set, remove the bit while pulling
the chuck cover in the direction of the arrow.
► 1 . Bit 2. Chuck cover
Hold the root of dust cup and pull it out.
NOTE: If the cap comes off from the dust cup, attach
it with its printed side facing up so that groove on the
cap fits in the inside periphery of the attachment.
14 ENGLISH
1
2