Download Print this page
Tapman TX2 Operating Instructions

Tapman TX2 Operating Instructions

Programmable timer
Hide thumbs Also See for TX2:

Advertisement

Quick Links

t
®
APMAN
Specifications
Display:
0.56" height 3 digit Red.
Time ranges: 9.99 / 99.9 / 999 sec,
9:59 min:sec, 99.9 / 999 min, 9.99 /
99.9 / 999 Hrs.
Counting
Direction:
Up / Down.
Modes:
a) ON delay b) Interval c) Cyclic On
first d) Cyclic OFF first.
Time setting: By front keypad.
Outputs:
2 C/O.
Relay rating: 7A @ 240VAC.
Inputs:
a) START b) RESET
Reset:
a) Front panel. b) Rear terminal. c) On
power interruption.
Reset Time: Less than 100ms.
Accuracy:
±0.05% or 50msec which ever is
greater.
Supply:
220VAC ±10% @ 50 / 60 Hz.
Mounting:
Panel mounting.
Housing:
ABS.
Operating
Temperature: 0˚C to 50˚C.
Humidity:
95% R.H. Non condensing.
OPERATING MODES
Specifications subject to change as development is a continuous process.
OPERATING INSTRUCTIONS
PROGRAMMABLE TIMER
Precautions during use
High voltage spikes (noise) present in the industrial
environment can cause malfunctioning of the
instrument like erratic display, latch up, data loss or
permanent damage to the instrument.
To reduce the chances of malfunction
a) Use of MOV across supply of timers and snubber
circuits across loads are recommended.
b) Use separate shielded wires for inputs.
SET VALUE PROGRAMMING
1. On-delay / Interval mode
a. Keep the
button pressed for 3 seconds.
b. The display shows the Set value and starts to
flash (on and off).
c. Using
and
value.
d. While the display is still flashing press
2. Cyclic On-first/ Cyclic Off first mode.
a. Keep the
button pressed for 3 seconds.
b. The display shows
c. Keeping the
button pressed use
buttons to select
d. Leave the
button.
e. Now the display shows the corresponding set
value.
f. Using
and
value.
g. While the display is still flashing press
RESETTING THE TIMER
1. By front panel:
Press the
and
seconds.
2. Remote reset:
TX2 can be reset from a remote push button by
shorting the RST and COM terminals.
buttons change to desired
and starts flashing.
and
(On time) or
(Off time).
buttons change to desired
buttons together for 3
TX2_Manual Ver: 1.0
www.microsmartindia.com
TX2
button.
button.

Advertisement

loading

Summary of Contents for Tapman TX2

  • Page 1 Press the buttons together for 3 seconds. 2. Remote reset: TX2 can be reset from a remote push button by shorting the RST and COM terminals. Specifications subject to change as development is a continuous process. TX2_Manual Ver: 1.0 www.microsmartindia.com...
  • Page 2 Set value to 0. On delay CONFIGURATION Interval TX2 is a multifunctional timer. To make it function in Cyclic with ON time first. Mode the desired way it has to be configured. Cyclic with OFF time first.