Mocka Rookie Assembly & Instruction Manual

Enlarged version

Rookie Bike

Thank you for your purchase.

Please follow the instructions below for correct assembly.

long screw

steering axle

Hardware Supplied

Mocka Balance Bikes are designed for children aged 2-6 years. These bikes

should not be used on public roads or near traffic. Wearing a helmet is

advisable. Only one child at a time should use the bike. Recommended for

children under 35 kg.

Adult supervision is strongly recommended at all times. Ensure your child is

confident at braking and is aware of road rules & safety. All screws, steering

and axles must be checked by an adult before use.

Please keep your bike protected from water and moisture. Due to the wooden

nature of the bike, they should not be left outside for long periods of time and

should be dried down after use. We recommend storing your bike inside when

not in use. Clean with a damp cloth - do not use chemical spray cleaners.

mocka.co.nz | mocka.com.au

wheel assemblies

Allen key

(in place) x2

All nuts and bolts must be checked and tightened before first

use. Regularly check all screws are tight to ensure safety.

Table of Contents

Do you have a question about the Rookie and is the answer not in the manual?

Page 1: Assembly Instructions
(in place) x2 Hardware Supplied Mocka Balance Bikes are designed for children aged 2-6 years. These bikes should not be used on public roads or near traffic. Wearing a helmet is advisable. Only one child at a time should use the bike. Recommended for children under 35 kg.
Page 2 Firstly separate wheel assemblies (C) and insert plastic spacers into The Rookie Bike has been pre-assembled with the seat in the lowest both wheels as shown. Slide bike wheels into position and attach to position for a beginner rider. Position the frame and fork of the bike both the frame and fork using the bolts and nuts.
Page 3 Rookie Bike Assembly Instructions Connect the frame and fork using the steering axle rod (A). Slide the Using the two long screws (B), attach the handle bars to the top of the rod down into the central hole in the top an through the end of the steering section.
Page 4 Rookie Bike Assembly Instructions Use allen key (D) to release and re-tighten the pre-assembled screws All done! We are confident your child will have years of fun and and bolts to adjust the seat. adventure while developing fantastic balance and co-ordination skills!