Download Print this page

Installation Instructions - Remington RMLS-330 Instruction Manual

17'ladder treestand

Advertisement

INSTALLATION INSTRUCTIONS PAGE 1
1.
2.
2. Position bottom of stand 4-5 feet from
base of tree.
WARNING
DO NOT climb ladder without stabilizer bar
installed. Serious injury or death may occur if
stabilizer bar is not installed.
Distributed by Primal Vantage Company Inc. 685 Route 10 East, Randolph, NJ 07869
CUSTOMER SERVICE DEPARTMENT 1-866-972-6168
1. Attach Ratchet Strap
R
to the outermost corners of each Tree Connection Brace.
(See Ratchet Instructions).
Attach Installation Cross Straps
(See Installation Strap Instructions).
3.
3. One person will stand at the base of ladder with
his/her foot on bottom rung while holding installation
straps. This will prevent tree stand from sliding. Two
people will stand at opposite ends of tree stand,
facing Platform and slowly walk tree stand upward
using rungs of ladder.
Stabilizer Bar and Installation Straps
MUST be secured prior to climbing the
Ladderstand. Failure to comply may result
in serious injury or death.
NOTE: Drawings are for illustration purposes only and may not depict actual product.
T
R
T
just behind the Ratchet Straps.
WARNING
WWW.TREESTANDCUSTOMERSERVICE.COM
MODEL: RMLS-330
All Season Deluxe
17' LADDER TREESTAND
4.
4. As tree stand is being raised, the person
holding Installation Straps will pull toward
themself to take up slack. It will steady and
ease the weight of stand on the other two
people. Continue walking stand upward,
until Tree Contact is resting against the tree.
©2012 (rev. 03/12)

Advertisement

loading