For Your Safety - ABB GSec/T1 Instructions For Installation, Operation And Maintenance

For your safety!

– Check that all the installation, putting into service and
maintenance operations are carried out by qualified
personnel with suitable knowledge of the apparatus.
– Make sure that all the installation, service and
maintenance operations comply with the standards
and laws so as to ensure that the installations are
constructed in accordance with the rules of good
workmanship and safety in the work place.
– Strictly comply with the instructions in this manual.
– Make sure that the rated performance of the apparatus
is not exceeded during service.
– Pay special attention to the information in the manual
highlighted by the following symbol:
– Make sure that the personnel are provided with this
manual and are aware of all the relevant information
while operating on the apparatus.
Responsible behaviour safeguards your own
and others' safety!
Please consult us if further details if required.
Issued by department
Doc. name
UniSec Handbook
Assembly
Operations
Workstation
S03
PICTURE
Work in safety: be aware of the DPI required by your works
Dalmine Italy
Date
31/01/2014
Warning !
To work in safe conditions, use the Personal
Protective Equipment (PPE) required in your
work station.
Contact your supervisor for special tasks
Foreword
The instructions in this manual refer to GSec switch-
disconnectors. Please read the manual carefully to ensure that
the product is used correctly. Besides this manual, it is always
necessary to consult the latest technical documentation
(circuit diagrams, connection diagrams, protection
coordination studies, etc.), especially regarding any variants
to the standard configurations required.
GSec switch-disconnectors must be built into medium voltage
switchgear.
Only use original spare parts conforming to the national
and international regulations for maintenance operations.
The manufacturer is responsible for compliance with such
regulations.
Lang.
ENG
Status of document
Doc. type
Creator
DESCRIPT
1. Select the panel
1.1. Push the "Avvia" button
1.2. Push the "Componenti da
Revis
1.0
Op
M.B
Tor
3