Installation; Before Your Start; Installing Your Module - Intellijel Audio Interface II Manual

Installation
Intellijel Eurorack modules are designed to be used with a Eurorack-compatible case and power
supply.
Before Your Start
Before installing a new module in your case you must ensure your case's power supply has
sufficient available capacity to power the module:
● Sum up the specified +12V current draw for all modules, including the new one. Do the
same for the -12 V and +5V current draw. The current draw will be specified in the
manufacturer's technical specifications for each module.
● Compare each of the sums to specifications for your case's power supply.
● Only proceed with installation if none of the values exceeds the power supply's
specifications. Otherwise you must remove modules to free up capacity or upgrade your
power supply.
You will also need to ensure you have enough free space (hp) as well as free power headers in
your case to fit the new module.
You can use a tool like ​
modules may result in damage to your modules or power supply. If you are unsure, please
contact us​ before proceeding.
Installing Your Module
When installing or removing a module from your case always turn off the power to the case and
disconnect the power cable. Failure to do so may result in serious injury or equipment damage.
Ensure the 10-pin connector on the power cable is connected correctly to the module before
proceeding. The red stripe on the cable must line up with the -12V pins on the module's power
connector. The pins are indicated with the label -12V, a white stripe next to the connector, the
words "red stripe", or some combination of those indicators.
M odularGrid​ to assist in your planning. Failure to adequately power your
Audio Interface II Manual
Page 3