Support - ABOX42 M30 User Manual

7. Support

Please contact your network operator for any support questions.
Manufacturer Address:
ABOX42 GmbH
Amalienbadstrasse 41
76227 Karlsruhe
Germany
www.abox42.com
10
Update search
Select the most current software version and
confirm with OK. The update of the software will
now start. Confirm completion of the update with
Continue . The installation has now been com-
pleted and the M30 device will be re-started. This
process may take up to one minute. Please do
not disconnect the device from the power supply.
Changes or modifications not expressly approved by the party responsible for compliance could void
the user's authority to operate the equipment.
This equipment has been tested and found to comply with the limits for a Class B digital device, pursu-
ant to Part 15 of the FCC Rules. These limits are designed to provide reasonable protection against
harmful interference in a residential installation. This equipment generates, uses and can radiate radio
frequency energy and, if not installed and used in accordance with the instructions, may cause harmful
interference to radio communications. However, there is no guarantee that interference will not occur in
a particular installation.
If this equipment does cause harmful interference to radio or television reception, which can be deter-
mined by turning the equipment off and on, the user is encouraged to try to correct the interference by
one or more of the following measures:
-- Reorient or relocate the receiving antenna.
-- Increase the separation between the equipment and receiver.
-- Connect the equipment into an outlet on a circuit different from that to which the receiver is con-
nected.
-- Consult the dealer or an experienced radio/TV technician for help.
（5G（
(1)the device for operation in the band 5150-5250 MHz is only for indoor use to reduce the potential for
harmful interference to co-channel mobile satellite systems;
(2)the maximum antenna gain permitted for devices in the band 5725-5825 MHz shall comply with the
e.i.r.p. limits specified for point-to-point and non point-to-point operation as appropriate.
(3) Users should also be advised that high-power radars are allocated as primary users (i.e. priority
users) of the bands 5250-5350 MHz and 5650-5850 MHz and that these radars could cause interfe-
rence and/or damage to LE-LAN devices.
This equipment complies with FCC radiation exposure limits set forth for an uncontrolled environment.
This equipment should be installed and operated with minimum distance 20cm between the radiator
and your body. This transmitter must not be co-located or operating in conjunction with any other an-
tenna or transmitter.
11