Keith McMillen Instruments QuNeo Reference Manual page 11

●
Rotaries -
Note - Press and hold the rotary in the top
left sector.
■
Pressure CC# - Press and hold the rotary in
the top right sector.
■
Location CC# or Direction CC# - Press and
hold the bottom sector of the rotary.
■
● Buttons - To output the Note quickly tap the button. Press and hold for 1 second
to output the Pressure CC#. If buttons are assigned to bank switching they will not
output their own data in CoMA mode, but instead control the banks for the Sliders
or Rotaries they are assigned to. Use the bank buttons to shift through banks, then
map the MIDI data for each of the Slider or Rotary banks.
Tip: Before using CoMA mode to map presets, consult the
whether the Pads are in Grid Mode or Drum Mode for the preset you are mapping. Pad
mapping works differently for Drum and Grid mode. Also check which data sources are
enabled. There may be presets with Notes or Pressure turned off. When data sources are
turned off, they will not output in CoMA mode.
The LEDs in the top left will illuminate
as soon as the note is sent out. (As
shown in image to the right).
The LEDs in the top right will
illuminate. (As shown in image to
the right).
The LEDs along the bottom will
illuminate. (As shown in image to
the right).
Factory Preset Guides to check
11