Middle Atlantic Products UPS-OLIPCARD Quick Start Manual

Quick Start Guide
UPS Online Network Interface Card
UPS-OLIPCARD
PRODUCT FEATURES
An Intelligent UPS Online Network Interface Card allowing a
UPS system to be managed, monitored, and configured remotely via
the web.
PRODUCT DOWNLOADS
Access the following link to download the SNMP Card Configuration
Tool and the UPS-OLIPCARD User Manual:
www.middleatlantic.com/downloads
INSTALLATION
Step 1. Hardware Installation
WARNING: Unplug and allow the equipment to fully discharge before
performing installation steps.
AVERTISSEMENT: Débranchez et laissez l'appareil se décharger
complètement avant peforming étapes d'installation.
WARNING: For safety instructions, refer to the "UPS-OLIPCARD User
Manual" via the link provided on the first page of this guide.
AVERTISSEMENT: Pour obtenir des instructions de sécurité, se reporter
à la "UPS-OLIPCARD User Manual" via le lien ou le code de QR fourni
sur la première page de ce guide.
1. Remove the two retaining
screws of the expansion slot,
and then remove the cover.
2. Install the Middle Atlantic
UPS-OLIPCARD into the
expansion slot.
3. Insert and tighten the retaining
screws.
4. Connect an Ethernet cable to the
Ethernet port of the Middle Atlantic
UPS-OLIPCARD.
NOTE: The Middle Atlantic UPS-OLIPCARD
is hot-swappable, so you do not need to turn
off the device to install it.
LINK Indicator
Universal Port
Universal
Definitions for LED Indicators
Link LED color
The UPS-OLIPCARD is not
connected to the Network or the UPS
Off
UPS-OLIPCARD power is off
The UPS-OLIPCARD is
On (Yellow)
connected to the Network
Tx/Rx LED color
Off The UPS-OLIPCARD power is off
On (Green) The UPS-OLIPCARD power is on
• Receiving or transmitting data packets
Flashing
• Reset finished
Step 2. Configure the IP address for the UPS-OLIPCARD
Method 1: Using the UPS-IPCARD Setup Utility
1. Install the UPS-IPCARD Setup Utility from the link provided on the
first page of this guide. Double-click the installation file named
MAP_SNMP_Setup.msi to start the installation.
2. After the installation is complete, run the Middle Atlantic UPS-OLIPCARD
Setup Utility by selecting All Programs > Middle Atlantic Products >
UPS-IPCARD Setup Utility.
3. The main dialog of the UPS-IPCARD Setup Utility is shown in
Figure 1. The configuration tool shows all network interface cards
present on the same network subnet. Click Refresh to search the
local network subnet as desired.
Figure 1. The main window of the Middle Atlantic Products UPS-IPCARD Setup Utility.
4. Select the UPS-OLIPCARD you are setting up. Click Tools >
Device Setup, or double click the card you wish to configure from the
list shown.
5. You can modify the IP Address,
Subnet Mask, and Gateway
address for the device's MAC
address listed in the Device
Network Settings window, as
shown in Figure 2.
The factory
default IP Address is
192.168.20.177 and the default
Subnet Mask is 255.255.255.0.
6. Modify the IP, Subnet Mask, or
Gateway Address. Enter the new
addresses into the corresponding
fields, and then click Save.
Ethernet Port
Tx/Rx Indicator
Link Tx/Rx
UPS-OLIPCARD
Condition
Figure 2. The Device Network setting window.
I-00789
Rev D