Advertisement
Installation Instructions
6300 Surface Mounted Rim Strike
Important: The New 6300 Electric Strike is never to be used as a door stop. Please install stops on frame
in appropriate locations. Ensure the exit device functions as intended for life safety concerns by verifying
electric strike and exit device compatibility. Maximum latch projection is essential to obtain full holding force.
When installed in a fail secure manner, the local Authority Having Jurisdiction shall be consulted with regard
to the use of selected panic hardware to ensure emergency exit from the secured area.
Catalog Specifications
Model
Mode
6300
Fail Secure
6300
Fail Secure
Fail Locked = Fail Secure = FSE DC = Direct Current
Continuous Duty = Energized 1 minute or more
Dimensional Details
IS6300-R05/10
Copyright © 2011 Ingersoll-Rand. All rights reserved.
Voltage
Current
12V
DC
24V
DC
9"
8-1/4"
(228.6mm)
(209.6mm)
Duty
Amps
Continuous
0.50
Continuous
0.24
1-3/4"
(44.5mm)
HORIZONTAL
ADJUSTMENT
MOUNTING
HOLES
5-1/2"
(139.7mm)
LOCK DOWN
HOLES
Ohms
22
89
3/4"
(19.0mm)
1-5/8"
(42.0mm)
Advertisement
Table of Contents
Related Manuals for Von Duprin 6300
Summary of Contents for Von Duprin 6300
-
Page 1: Installation Instructions
6300 Surface Mounted Rim Strike Important: The New 6300 Electric Strike is never to be used as a door stop. Please install stops on frame in appropriate locations. Ensure the exit device functions as intended for life safety concerns by verifying electric strike and exit device compatibility. - Page 2 Instructions 1. Determine the horizontal centerline of the exit device latch and transfer centerline to the frame stop. 2. Position the template onto the frame aligning with centerline and against the closed door. Center-punch the two mounting holes and the wire access hole as shown. 3.
- Page 3 IRT6300_R0610.qxd 6/18/10 10:34 AM Page 1 5/8" (15.9 mm) 6300 TEMPLATE ø3/4" (ø19.0 mm) SURFACE MOUNTED RIM STRIKE WIRE ACCESS HOLE INSTRUCTIONS 1. Determine the horizontal centerline of the exit device 23/32” latch and transfer centerline to the frame stop.
Need help?
Do you have a question about the 6300 and is the answer not in the manual?
Questions and answers