Honeywell POL-200-TS User Manual page 15

According to the protocol used (refer to par. 3.5), the system shows the position and the type of
device connected.
CLIP PROTOCOL
• "O" Optical Sensor
• "H" or "T" Heat/Thermal sensor
• "I" ionization sensor
• "M" Multi-Sensor. Optical/ thermal
• "P" Pinnacle Laser
• "L" VIEW Laser
• "S" Smart Multi-criteria
Section of Modules - Symbols of identifica-
tion by type:
• "I" or "E" Input Modules including
Manual Call Points
• "O" or "S" Output modules
• "R" Output modules without End-of-
Line (EOL) by default Relays
• "Z" Zone modules for conventional de-
tectors
To select between CLIP and ADVANCED Protocol please access the configuration screen and
select one of the two protocols available from the button line.
Lower Case or Capital Letter: if a lower case letter appears in the reading cycle, please confirm
in the configuration that the correct protocol is selected among these different options "Notifi-
er", "Morley", "System Sensor" or "Honeywell HBS".
In case in one address a device changes the type ID or in case of a change from lower case
to capital letter, please check the wiring in this device as its answer is not correct. This can be
caused by a defective device or noise due to interferences.
POL-200-TS User Manual
ADVANCED PROTOCOL
For advanced protocol loops, POL-200-TS
also identifies the following elements:
• "S" SMART 4
• "B" Beam detectors
• "P" Indoor Manual Call Point
• "M" FAAST Aspiration unit
15