Advertisement
EVM is covered. The green LED on the EVM hardware indicates power, and the red LED indicates if
an interrupt event has occurred. The LEDs will be enabled at the start of the utility and can be turned
on/off as an application preference from this menu item.
The Main form also supports the capability of logging the current state to a file from the 'File' menu
item. This feature is useful for studying the lux-to-nits relationship for a particular LCD panel. This
feature can be accessed from the menu. Simply enable logging and select the interval at which to log
the data.
The firmware version of the EVM is noted in the lower right hand corner on the status bar.
The Settings form exposes the following key TSL2560/61 device registers:
1. Control Register (0h): Primarily used to power up/down the TSL2560/61 device
2. Timing Register (1h): Controls the integration time and gain of the ADC channels
3. Interrupt Control Register (6h): Controls the interrupt capabilities of the device
4. Interrupt Threshold Registers (2h-5h): Stores the high and low trigger points for
the comparison function for interrupt generation
An Evaluation System for the TSL2560/61 Ambient Light Sensor
Figure 6. Device Utility Logging Dialog
10 of 11
www.taosinc.com
Advertisement
