DeWalt DXPW3694 Instruction Manual page 4

WARNING: Do not operate this unit until you read this instruction
manual and the engine instruction manual for safety, operation and
maintenance instructions.
WARNING: When using this product basic precautions should
always be followed, including the following:
1. Read all instructions before using the product.
2. To reduce the risk of injury, close supervision is necessary when a
product is used near children.
3. Know how to stop the product and bleed pressures quickly. Be
thoroughly familiar with the controls.
4. Stay alert–watch what you are doing.
5. Do not operate the product when fatigued or under the influence of
alcohol or drugs.
6. Keep operating area clear of all persons.
7. Do not overreach or stand on unstable support. Keep good
footing and balance at all times.
8. Follow the maintenance instructions specified in the manual.
DANGER: RISK OF INJECTION OR SEVERE INJURY. KEEP
CLEAR OF NOZZLE. DO NOT DIRECT DISCHARGE STREAM
AT PERSONS. THIS PRODUCT IS TO BE USED ONLY BY
TRAINED OPERATORS.
WARNING: This product may not be equipped with a spark-
arresting muffler. If the product will be used around flam ma ble ma teri-
als or on land covered with materials such as agricultural crops,
forest, brush, grass or other similar items, then a Spark Emission
Control Device that complies with Australian Standard "AS 1019-2000
Internal Combustion Engine - Spark Emission Control Devices" must
be installed.
SAVE THESE INSTRUCTIONS
DANGER: RISK OF EXPLOSION OR FIRE
WHAT CAN HAPPEN
• Spilled gas o line and it's
vapors can be come ignited
from cigarette sparks,
electrical arcing, exhaust
gas es and hot engine
components such as
the muffler.
• Heat will ex pand fuel in the
tank which could result in
spillage and pos si ble fire
explosion.
4
HOW TO PREVENT IT
• Shut off en gine and allow
it to cool before adding fuel
to the tank.
• Use care in fill ing tank to
avoid spill ing fuel. Move
pressure wash er away
from fueling area before
start ing en gine.
• Keep maximum fuel level
12.7 mm be low
bottom of filler neck
to allow for expansion.