This product is powered directly from the mains supply and should only be fitted by a qualified electrical installer. Placement • The WA-210 can be installed into a partition wall using a standard 38mm deep pattress box • The WA-210 can be surface mounted if necessary with a suitable back box •...
(see opposite) If the WA-210 is supplied without speakers, ensure that the load to be connected to each speaker output has no lower than 8Ω impedance and has a power handling of 10W max.
Page 4
Fit the WA-210 into the wall or back box using the 2 screws and press on the fascia until it clicks in place, ensuring that the lower edge inputs and power switch remain accessible.
On/Off slide switch Operation To power up the WA-210, slide the On/Off switch on the underside to the “ON” position (18) The LCD screen will light up and show the status (12) Control is available from the front panel or via the supplied I.R. remote control handset.
Some additional functions are available for playback on the remote control. The WA-210 can be powered down or powered on remotely using the Power on/off key The mode is selected by pressing the M key followed by a number 1 to 6.
Pressing the EQ button on the remote steps through Pop, Rock, Jazz or Normal presets. Bluetooth Mode The WA-210 may be paired to a smart phone or tablet via Bluetooth for wireless playback. Enable Bluetooth on the sending device and search for the device ID “DABA”.
Page 8
Bluetooth version 2.1 + EDR Remote : battery CR2032 Dimensions 86 x 86 x 37mm Weight 128g Specifications: Ceiling Speakers (WA-210-SET) Driver 165mmØ (6.5”) dual reinforced paper cone Cutout 165-170mmØ Mounting depth 65mm Frequency response 110Hz – 15kHz...