Advertisement
OPERATION BABY UNIT (BU)
1. Place the BU about 1 m from the crib with the microphone
the baby. Switch on the unit by long press of power button
the power indicator
flashing green, the battery level becomes low and need to be recharged
using the supplied USB nightlight.
At the same time, the LED level meter
around 5 sec. More LED light up means the battery is more full. Momentarily
press of the power button
To switch off the unit, long press the power button
2. Adjust the microphone sensitivity using the Mic sens button
such that the unit will be set to transmit whenever the microphone
up a sound at your desirable loudness level. The LED level meter
change as these buttons are pressed, more number of LED light up means
the microphone is more sensitive to sound (maximum is 5 LED and
minimum is 1 LED). Press
reduce microphone sensitivity.
3. Once BU is in transmit mode, the LED level meter
with the sound being picked up by microphone
standby mode a few seconds after the microphone
any sound and the LED level meter
will show steady green. If this indicator starts
I 4
at anytime can show the battery status.
I 1
+
button
2
goes off.
5
6
will show the battery status for
5
again for over 2 sec.
I 1
to increase and
will start flashing along
5
. The unit will return
6
stops picking up
6
facing towards
6
for 2 sec,
I 1
+
2 3
picks
6
will
5
button
to
3
Advertisement
