Advertisement
Attaching pads to rack
1
Loosen L-rod wing nuts on drum pad clamp.
Insert textured plastic end of L-rod into tom clamp and tighten wing nuts.
2
Repeat for each drum pad clamp.
Loosen wing nut on pad.
3
Attach pads to L-rods and tighten wing nuts. Repeat for each pad.
4
1
Attaching cymbals
1
Insert each boom cymbal arm into pillar(L1)and pillar(R1,R2).
Remove wing nut and felt washer from cymbal tilter.
2
Place cymbal pad on tilter assembly.
3
Re-attach the felt washer and wing nut. Tighten wing nut.
Note: Cymbals are arranged as follows:
12" crash on left-side boom arm, 14" ride on right-sideboom arm,
12" crash2 on right-side boom arm.
Wing Nut
Felt Washer
Wing Nut
Felt Washer
2
Pillar(L1)
Pillar(R1)
Pillar(R2)
14"
12"
12"
11"
11"
11"
11"
Attaching module
Loosen the wing screw on the clamp
1
Insert the drum module to the clamp
2
Tighten the wing screw on the clamp
3
2
Insert the drum module
1
Loosen the wing screw
Bass drum and Hi-Hat pedal
Place the kick pad on the floor in the center of rack.
1
Attach your kick pedal to the kick pad.
2
Place the
Hi-Hat stand with actuator and pad attached
on the floor on your left side.
3
Please connect the clearly marked cables from the pads to the correct inputs on the drum module, and you are ready to play!
12" Cymbal Pad
11" Pad
12" Hi-Hat Pad
11" Pad
Kt4 Drum module
Kick pad
Hi-Hat Stand
3
Tighten the wing screw
14"
Ride
Cymbal Pad
12" Cymbal Pad
Pad
11"
11" Pad
1
kick pedal(option)
Advertisement
