KAT Percussion KT4 Assembly Instructions

KT4 ASSEMBLY INSTRUCTIONS
Watch your fingers when adjusting clamps. They may become pinched resulting in injury.
Be careful around pipe ends, inside the pipe and screw ends. Metal shavings, etc. May injure your fingers.
Inside This Package
Before assembly, please make sure that all the items listed below are present.
[14" CYMBAL PAD] BOX [12" CYMBAL PADS] BOX
14" Cymbal Padx1 12" Cymbal Pads x 2
[11" DRUM PADS] BOX
11" Drum Pad x 4
DRUM RACK
Pillar(L1) Pillar(R1) Pillar(L2) Pillar(R2)
ACCESSORY BOX
Boom drum Arm of Tom3 L-Rod of Tom3 Tennis ball beater Hexagon Key (M5)
Boom Cymbal Arms X 3 L-Rods of Pads X 3 Cable Tie wraps X 8
Caution !
Hi-Hat]
[12" BOX
12" Hi-Hat
Hi-Hat cup Felt
Cymbal Pad x 1
Cymbal Clutch Power Cable - Y type
[DRUM MODULE] BOX [ KICK PAD
Module Kick Pad
Center Pipe(1)
[Hi-Hat Stand] BOX
Hi-Hat Stand
Center Pipe(2)
Side Arm(L1)
Side Arm(R)
Snare pad arm(L2)
Drum Key Foot Cable for crash Connection Cables
SD Card AC Adapter Hand Screws X 2 Drumsticks X 2
Assembly
Assembly
1 Setting up the KT4 drum rack
[1] Attach the Center Pipe(1) to the clamp on the
[2] Attach the Center Pipe(2) to the clamp on the
[3] Attach the Center Pipe(1)(2) to the clamp on the
[4] Using the wing nut tighten the screws on the clamp.
[5] Attach the side arm (L1) to the clamp on the
[6] Tighten the screws on the clamp.
[7] Attach the side arm (R) to the clamp on the
Hi-Hat Controller
[8] Tighten the screws on the clamp.
[9] Attach the side arm(L1) to the clamp on the
[10] Tighten the screws on the clamp.
[11] Attach the side arm(R) to the clamp on the
[12] Tighten the screws on the clamp.
[13] Attach the snare pad arm
[14] Tighten the screws on the clamp.
] BOX
Side Arm(L1)
6
Pillar(L2)
Owner's Manual
Setup Manual
front left vertical pillar(L1)
front left vertical pillar(L1)
front right vertical pillar(R1)
back left side vertical pillar(L2)
back right side vertical pillar(R2)
front left vertical pillar(L1)
front right vertical pillar(R1)
(L2) to the clamp on the front left vertical pillar(L1)
Pillar(R1)
3
Center Pipe(1)
3
Center Pipe(2)
5
7
Side Arm(R)
8
Pillar(R2)
Pillar(L2)
Pillar(R1)
11
12
Side Arm( )
R
Pillar(L1)
1
Center Pipe(1)
2
Center Pipe(2)
Tighten the screw
Tighten the screw
4
4
Tighten the screw
Tighten the screw
Pillar(L1)
9
10
Pillar(L1)
13
14
snare pad arm(L2)